Notifications
Clear all
fuzzybubblesiii
@fuzzybubblesiii
Eminent Member
Joined: Nov 24, 2012
Topics: 7 / Replies: 16
Reply
5 years ago
Forum
Reply
RE: Vixen 2 Pixel Controller compatibility

MikeKrebs wrote:I believe the RP 4 output controller is multicast only. Does the vixen 2 e1.31 driver support multicast? Not sure what I did but as ...

5 years ago
Reply
RE: Vixen 2 Pixel Controller compatibility

I have attempted to run a test with vixen 3 and the renard plus 4 using the E1.31 setting as a controller. I have yet been able to be successful in ge...

5 years ago
Reply
RE: Vixen 2 Pixel Controller compatibility

I do want to use the 595 as long as I can. It has continued to work and has not let me down. Fully tested in weather from below freezing and snow in u...

5 years ago
Reply
RE: Vixen 2 Pixel Controller compatibility

You are correct with the Ren-C. I have two bare Ren-C boards acquired when I first got the olsen that I never put together. Also got the Ren-T for the...

5 years ago
Reply
RE: Vixen 2 Pixel Controller compatibility

Yes I Am referring to a Renard Plus 4 Output Combo not a Raspberry Pi 4. My apologies on the confusion. I have been looking for a good enough reason t...

5 years ago
Reply
RE: Vixen 2 Pixel Controller compatibility

MartinMueller2003 wrote:If Vixen 2 (have not touched it in years) supports E1.31 then any of the Ethernet / WiFi controllers will work. I did locate...

5 years ago
Topic
Replies: 11
Views: 8406
Reply
RE: Renard Plus 4 Output Combo Controller Vixen3 Setup

MikeKrebs wrote:The 4 output combo controller is a multicast e1.31 controller. you set the start universe via jumpers and the rest of the universes fo...

5 years ago
Forum
Topic
Forum
Replies: 3
Views: 3258
Reply
RE: upgrading show so upgrading software. will my old hardware work?

jchuchla wrote:Don't you need a parallel port to use the olson? Do you even have a computer that still has one? I've also heard that parallel suppor...

5 years ago
Reply
RE: upgrading show so upgrading software. will my old hardware work?

jchuchla wrote:I just looked up the ren-C and it looks like a converter to enable serial control of your olsen 595. It looks like you also need to u...

5 years ago
Reply
RE: upgrading show so upgrading software. will my old hardware work?

jchuchla wrote:It was removed in august 2018 in version 3.5 under ticket VIX-2312. So 3.4.3 or earlier should still have it. You can find all of our ...

5 years ago
Reply
RE: upgrading show so upgrading software. will my old hardware work?

jchuchla wrote:Vixen 3 dropped support for the Olsen 595 controllers a few years ago. We did a survey and the Olsens were among the legacy controller...

5 years ago
Page 1 / 2
Share: