What pixel controllers work with vixen2? I use an older pc and vixen 2 because it has a parallel port and I use a 595 controller for my on/off lights. Cant use vixen 3 on the controller pc because There are no driver support above Vista for the motherboard. I have a new RP4 output combo board but I have yet to have any luck figuring out how to use it with vixen 3 on my main pc. My main pc is too new to have a parallel port. I guess I'm in need of a few answers. 1: Should I get a different pixel controller that will work with vixen 2 so I can continue to use the 595 controller? 2: Attempt to figure out what I'm doing wrong with the RP4 output combo board on my main pc and use that with vixen 3? 2B: If I go this route should I order a parallel port expansion card for my pc so I can continue to use the 595 controller? 3: Should I just put the 595 on the shelf and get a newer more modern controller for my string lights and then run it all thru my main pc(Once I can get the RP4 output combo board working)? Just frustrated and looking for a little advice. Thanks!!
If Vixen 2 (have not touched it in years) supports E1.31 then any of the Ethernet / WiFi controllers will work. In addition you could try to use a PX1 to control up to 250 pixels on a USB serial port.
As for the RP4, put FPP on it and have it drive your board using the "outputs->other->GPIO-595" setting. Then you just need to move to a sequencer that can output an FSEQ file for the FPP to play.
MartinMueller2003 wrote:If Vixen 2 (have not touched it in years) supports E1.31 then any of the Ethernet / WiFi controllers will work.
I did locate a E1.31 patch for vixen 2. Do not know if its working properly because I have had no luck getting the PR4 combo to do anything on both vixen 2 and the older pc w/parallel for the olsen 595 and my newer pc using vixen 3. Still not convinced the RP4 is isn't the problem to the pixel controller issue. Willing to buy a parallel expansion board for the newer pc so I can continue using the 595 controller for a foe more years until I figure out pixels and switch over completely down the road
MartinMueller2003 wrote:As for the RP4, put FPP on it and have it drive your board using the "outputs->other->GPIO-595" setting. Then you just need to move to a sequencer that can output an FSEQ file for the FPP to play.
So your saying FPP will load and properly function on a Renard board? I loaded the firmware on the FPGA board as instructed. Willing to try FPP if it will work on this controller. Thanks for your reply. Definitely some new options to consider...
FPP will load and run on a Raspberry PI including the RP4 (aka Raspberry PI 4). It is possible you mean something else by RP4. At any rate, the FPP application running on a Raspberry PI has A LOT of GPIOs available and it supports a GPIO 595 output mode so somewhere there is a way to connect your 595 controller to a Raspberry PI and have the FPP play a sequence using it. That means that same FPP can output E1.31 data to a pixel controller and it would seem that you have everything you need to move to Vixen three (which generates FSEQ files for the FPP to play). Just did a quick search and the searches come up with ways to attach a 74hct595 shift register to the PI giving you more IO ports. I suggest you ask on the falcon web site if the GPIO-595 is referring the the Lighting controller or the shift register.
Yes I Am referring to a Renard Plus 4 Output Combo not a Raspberry Pi 4. My apologies on the confusion. I have been looking for a good enough reason to get myself a Raspberry Pi and start learning to play with one. Maybe this is the reason. Lol
