Activity
 
Notifications
Clear all
Entropy
@entropy
Honorable Member
Joined: Dec 24, 2007
Topics: 8 / Replies: 589
Reply
RE: RGB Pixel Nodes over Ethernet - New Design

David_AVD wrote:Hmmm.... interesting. Any chance you can dig up where you found that? I can't seem to see anything about it at all. Unfortunately...

16 years ago
Forum
Reply
RE: RGB Pixel Nodes over Ethernet - New Design

secanell wrote:Interesting design, but one must then be careful on how long they make the string (aside from power requirements). If the spi master h...

16 years ago
Forum
Reply
RE: RGB Pixel Nodes over Ethernet - New Design

David_AVD wrote:Really? That directly contradicts the information I got from Philips: "Unfortunately, the Philips SSL license program is not directed...

16 years ago
Forum
Reply
RE: 3 channels to make all nodes of the GE 'Costco' RGB string the same color?

A few people targeted them with Arduino hardware which, if you strip out all the "extras", comes out to $5-10 for ATMegaXX8 + crystal + SN75176 (DMX r...

16 years ago
Forum
Reply
RE: Free PCB Design Software?

As I said - depends on board size. Suppose you have a small board - 2 square inches. Dorkbot will be $10 for 3 boards, so $3.33/board - Also, if you ...

16 years ago
Reply
RE: Electrical Engineers out there?

Gah... Unfortunately, along with going through three rounds of layoffs over the past two years, my company's co-op program is suspended for the forse...

16 years ago
Forum
Reply
RE: Free PCB Design Software?

How economical Seeed's service is depends on the board size, since they have a fixed price per board. A hobbyist effort that is proving popular is La...

16 years ago
Reply
RE: RGB Pixel Nodes over Ethernet - New Design

David_AVD wrote:Put simply, the Philips patent covers the use of PWM to colour mix LEDs. There is no "chip license". The license applies to the asse...

16 years ago
Forum
Reply
RE: RGB Pixel Nodes over Ethernet - New Design

I was not referring to the 3-5050 modules, but the single diffused emitter modules, which have a form factor more appropriate for many Christmas uses....

16 years ago
Forum
Reply
RE: RGB Pixel Nodes over Ethernet - New Design

As far as existing designs, other than the fact that the Propeller is a bit of an unusual chip with an even more unusual language and no open source d...

16 years ago
Forum
Reply
RE: Oscilloscope

It's interesting for the price. However - claims 1 MHz analog BW but only has 1 MSPS sampling rate. General rule of thumb is that for proper scope u...

16 years ago
Reply
RE: RGB Pixel Nodes over Ethernet - New Design

I really don't think RGB is best done as a ground-up design, not when there are some VERY good candidates for the nodes themselves (such as WS2801 pix...

16 years ago
Forum
Reply
RE: DMX noob and RGB LED questions

njamateur wrote:Around the holidays I saw a video clip of someone who shows software that easily allows you to specify how RGB strings are connected b...

16 years ago
Forum
DMX
Reply
RE: 8 X 8 LED Matrix

Blackbeard wrote:12 or 6 mcd? Is that bright enough? Seems most of the "normal" LEDs are around 6000 mcd. What's the minimum brightness recommended? ...

16 years ago
Forum
Reply
RE: Soldering Station

Hmm, somehow my first reply to this didn't get posted. Still getting used to the new forum software. The CSI-1/2 are as far as I can tell identical ...

16 years ago
Forum
Page 8 / 40
Share: