Activity
 
Notifications
Clear all
Entropy
@entropy
Honorable Member
Joined: Dec 24, 2007
Topics: 8 / Replies: 589
Reply
RE: Can I use the Mighty Mini as a permanent Installation?

Constant current won't help too much if the resistor values are chosen properly beforehand and a well regulated power supply is used. The key here is...

16 years ago
Reply
RE: The diyc $100.00 rgb project ???

caviar wrote:Is this something that is in our future, or are we all doomed to pay $300.00 for 1 strand of rgb lights. Well, it sure would be fun to ha...

16 years ago
Forum
Reply
RE: USB to DMX dongle - Enttec Pro compatible

ErnieHorning wrote:Here’s a through hole version from Germany though some stuff hasn’t been translated yet. Under the plugins section, it shows Vix...

16 years ago
Forum
DMX
Reply
RE: Military VHF Radio Antenna

Probably a forum dedicated to hams would be better than DIYC - fortunately, as you've discovered, quite a few of us are hams. I was going to recommen...

16 years ago
Forum
Reply
RE: USB to DMX dongle - Enttec Pro compatible

Obviously it should be possible to build a uDMX for far less than $250. However, one thing to keep in mind regarding that unit is that it is using "s...

16 years ago
Forum
DMX
Reply
RE: USB to DMX dongle - Enttec Pro compatible

In terms of familiarity, I think there's a mild majority of PIC users over AVR users here, but in this specific case, I think nearly all of the AVR us...

16 years ago
Forum
DMX
Reply
RE: USB to DMX dongle - Enttec Pro compatible

I think the problem with the lack of tweaks/upgrades is you're the only one here who can understand AVR assembler - the rest of us mere mortal AVR pro...

16 years ago
Forum
DMX
Reply
RE: USB to DMX dongle - Enttec Pro compatible

RPM wrote:I did, but I want to keep the Enttec Pro compatibility, so I decided to replace the module and keep the rest unchanged. Sent from my Samsu...

16 years ago
Forum
DMX
Reply
RE: USB to DMX dongle - Enttec Pro compatible

Have you considered possibly the further cost savings of just using a native-USB microcontroller like the ATMega32U4? In quantities of 10 or more it'...

16 years ago
Forum
DMX
Reply
RE: offsite mighty mini COOP - Interest Only thread

Personally, I would choose something that gives a bit of margin, especially since human vision is logarithmic and LED efficiency increases as current ...

16 years ago
Forum
Reply
RE: RGB color DMX snow tubes

miniboyink wrote:Perhaps you should have read the postings. 1. The units were designed to take DMX or be hooked in via a DVI controller (DMX & DVI - T...

16 years ago
Reply
RE: Logic Analyzer

jeffl wrote:I know it's more money but what about this one? Someone here does happen to use it - I think jstjohnz? That analyzer was mentioned i...

16 years ago
Forum
Reply
RE: offsite mighty mini COOP - Interest Only thread

Depending on price I might be interested in parts (LEDs, resistors), I have either 4 or 8 boards (can't remember) - but as said, it depends on price. ...

16 years ago
Forum
Reply
RE: What is the brightest?

griffixdc wrote:exactly the information and direction i was looking for .... do these super LED's require a driver or can they be powered off the sour...

16 years ago
Forum
Reply
RE: What is the brightest?

mcd values are mostly worthless as they take beam pattern into account. A 4000 mcd LED and an 8000 mcd LED can put out exactly the same amount of lig...

16 years ago
Forum
Page 4 / 40
Share: