For the ENC28J60 you will need to use a different library, either UIP library or Ethercard My code uses ethercard.
So what ethernet are you using? Make sure you are using the corresponding code for whichever one you are using. If it's an ENC28J60 module, test it ...
Is your PC and the Arduino in the same IP subnet? i.e what is the IP of your PC and the Adruino?
No reason it would not work on the mega (although there's no advantage). Make sure you can ping the device Check your Universe/Subnet to make sure ...
djred2000 wrote:I've run into a bit of a snag with using the W5100 ethernet shield to receive E1.31 data. The data buffer is only 2048 bytes so it ca...
Ahh, sorry, It's been so long I forgot you were using serial. I have never used serial so can't really offer advice on that.
what is your update rate in Vixen? If it's too high (number is too low), the ethernet module will not cope with the packet storm. Somewhere around 3...
Give me a day or two and I will try that code for you. I'l also see if i can sort out the UDPListener stuff too. Side note - have you tried The se...
Well I have some good news and some bad news. The good news is that i have managed to play around with it and discovered something that gets rid of t...
No, I have not tested on the Due.
post your complete code. There must be something wrong in it somewhere...
What are you using to test? Try something like da_e131.
What version of the Arduino IDE are you running? Compiles fine against 1.6.1 and 1.0.5 but I have heard of issues with newer versions. Scratch that -...
I have not found much difference with running 11's on 12B setting (and vice versa) but if you're having problems, set it to the right one just in case...
