Here are a couple of links to free sequences: Alternatively, in xlights you can go to tools-->Download Sequences/Lyrics, which will take you ...
This is a little concerning. I was planning on placing an order for pixels that will be permanently mounted to my eaves using j-channel, but I may ha...
MartinMueller2003 wrote:Not sure but I took my new matrix made from Ray Wu pixels down because it was flickering. Sometimes a pixel would stop forward...
gatoruss wrote:Total Noobie here. I have the following: 4 espixels (actually MCUnodes with espixelstick v3 firmware);I also have pi 3b+ configured a...
MartinMueller2003 wrote:That would require using the SPI interface which we are using for the SD Card. Was ws2801 support added to the latest ESPixe...
angus40 wrote:It would be interesting to see the guts of these . I have reservation about them being esp WiFi though . Almost all WiFi devices I have ...
So I recently found these floods, you can get a 50% discount using the code 50TRKRXV Since these are wifi enabled, I bet there's an ESP8266 or ESP3...
angus40 wrote:You could use WLED for your Ws 2801's Thanks, I'll look into this!
Any chance 4 wire pixels (ws2801) might be supported? I know the espixelsticks (esp8266) had a data clock, but it was never implemented.
Will the GE color effects still be supported? I use a number of these in my display.
MartinMueller2003 wrote:I have uploaded a fix that increases the timeout on the transfer 100x. I also removed some code that slowed the transfer down ...
On a side note, I tried using the flash tool to program one of the esp32 modules i have (hw-607). I got the following error in the serial output: F...
MartinMueller2003 wrote:I have been trying larger and larger files. I have no issue with fseq files under 100MB. I AM having an issue with a 200MB fse...
I just tried both firmwares with an lolin board and sd card attachment I made. I'm having the exact same issue, the older firmware works fine while t...
MartinMueller2003 wrote:I just programmed my WeMos D1 R1 using all three methods [Arduino IDE | Java Utility | Admin Page OTA] and it works fine. FYI:...
