For comparison purposes, here's a similar product from Ray Wu, but a lot more expensive and without the mating connectors or power supply:
Here's the xlights Facebook post, more good info about these: Here's another good link with info about these strips:
I don't know for certain, but logically it seems you should be able to cut it every 6 LEDs. However, you'd lose the waterproofing and the ability to r...
MartinMueller2003 wrote:If you are using FPP Remotes over WiFi you want as little (aka no) other traffic on the network. Avoid sending E1.31 traffic e...
MartinMueller2003 wrote:FPP Remotes communicate back to the FPP Master so that the Master knows they are there. It is a fairly small message and every...
Is your fpp player connected to your network wirelessly or through a network cable? You definitely want to use a network cable. Also when using e1.3...
TokyoLights wrote:Thank you, this gives me hope. If its just a tunning issue I can work through that. Are you using ESP Pixel stick or WLED or somethi...
TokyoLights wrote:Configured with E1.31, 2 universes per controller, its interesting you mention ESP pixel stick, I have much worse performance using ...
Have you tried toggling igmp snooping on/off and changing the multicast rate? 20 universes of data at 25ms timing probably won't work unless you have...
kev wrote:Multicast Most consumer grade router/AP combos do not handle multicast traffic very well. You might want to look into an ubiquiti nanosta...
Are you using unicast or multicast for the e1.31 data sent to the esps?
