Activity
 
Notifications
Clear all
DrWizard
DrWizard
@drwizard
Trusted Member
Joined: Oct 23, 2012
Topics: 11 / Replies: 37
Reply
RE: Controlling a single (for now) stepper motor with XLights?

consider adding some limit switches In my application I am turning a wheel so there are no limits, I just want to control direction and speed. And ...

7 years ago
Forum
DMX
Reply
RE: DMX Splitter - Isolation needed?

Thanks Mark for your input! a fault in one zone could potentially knock out all the others So how is having a non-isolated splitter any different or...

7 years ago
Forum
DMX
Reply
RE: Low Current AC Controller

I already have a Renard 32+ using DirkCheap SSRs with VO2223's but I have been unhappy with it. Dims and fades are very choppy and uneven. I suspect...

7 years ago
Forum
DMX
Reply
RE: Controlling a single (for now) stepper motor with XLights?

Glad I ran across this thread. I have been working on the same idea. I have it all working on my bench on a breadboard, still tweaking the software....

7 years ago
Forum
DMX
Topic
Forum
DMX
Replies: 7
Views: 11490
Reply
RE: New street light too bright.

Join the club. I have the same problem and have heard the same complaint from many others. Asking for a shield to be installed has worked for many p...

7 years ago
Forum
Reply
RE: NEED ADVICE Xmas Light Legal Battle

There are several cases like this that have gotten a lot of media attention over the last few years. In a few cases, the grinch neighbor was 'shamed'...

7 years ago
Forum
Reply
RE: Low Current AC Controller

dcamron wrote:I have a Wireless Renard/DMX in the works that uses an ESP32, MOC3023’s and an enclosed Buck. The goal for that design is a cheaper, low...

8 years ago
Forum
DMX
Topic
Forum
DMX
Replies: 10
Views: 20783
Reply
RE: LED Conversion Help Please

Resurrecting an old thread here... I too have been considering doing the same thing. I have a bunch of those Walmart candy canes I would like to con...

8 years ago
Forum
Reply
RE: Cheap DIY 12mm Pixel/RGB Mounting Strips

Forstner bits definitely work good for this, and for Coroplast. However, I have had even better results with "Brad Point" or "Bradpoint" bits, and ye...

8 years ago
Forum
Reply
RE: Some sparkly old pixels w/ AlphaPix16 controller - Compatibility? Timing issue?

Actually, as you describe it, that should cause the opposite problem. If the new longer reset was the problem, then my new pixels would not work but ...

8 years ago
Reply
RE: Buffer/line driver - null pixel without pixel

P. Short wrote:I'm assuming that the board is assembled two ways, one with a transmitter chip and one with a receiver? A five-pin chip doesn't have e...

8 years ago
Page 2 / 4
Share: