RobG wrote:The new 50W board has a built in driver, on the input and the output. 20W doesn't have one.
There was no GB this year.
There’s no GB this year for the drivers or the floods?
You have a separate thread taking orders for the drivers—and there have been many requests.
I actually placed order to have them manufactured in early October, but had to cancel due to issues with suppliers. I figured that at this point it is too late to start GB (it would take 2-3 weeks to have them here,) but if that's not a problem I can start one tomorrow. Flood boards should be here next week.
P. Short wrote:I'm assuming that the board is assembled two ways, one with a transmitter chip and one with a receiver? A five-pin chip doesn't have enough pins to have a direction-control pin.
There are 2 styles, or kinds.
One kind uses 'differential signalling' generally RS-485, and requires 2 boards, a transmitter and a receiver. This is best for really long runs or those subject to interference. This is the most expensive solution, as you need 2 boards and the transceiver chips are a little pricey (or at least I think so, for what they do) and you typically also need some sort of voltage converter or buck converter. This type works by having a continuous voltage, the precise amount is not critical, and by reversing the polarity of the 2 wires for the 1's and 0's. The receiver only needs to detect when the polarity changes and any voltage drop or any reasonable amount of electrical noise does not affect that.
The other kind, the 'null pixel' is a one part solution. The null pixel amplifies and cleans up the signal, making up for voltage drop in the cable by returning the signal to the full voltage, and 'square-ifying' the signal, removing stray interference and noise. Not only is this a one-piece solution, it also uses cheaper parts. This is referred to as a null pixel because the even easier and cheaper method is to just add an extra pixel at the beginning of the string and leave it turned off in your sequence. This works because the WS28xx pixel chips also amplify and clean up the signal themselves before sending it back out on their output side. A spare pixel though may not do as good of a job at this than a more specialized circuit. Null pixels (real or virtual) have their limitations though, and for really long runs you will need the differential signalling solution.
Oh, and it's a one-way signal so you don't need a reply pin.
Both types have been discussed above, and it's not always clear which style is being talked about.
If the group buy would be for the line drivers I'd be "on board" pardon the pun.
I only have a few left and plans to add more props in the coming year.
I just had 2 of these fail on me. Show was running flawlessly and then one prop started acting strange. I thought maybe it was a bad pixel so I took the prop down and tested the pixels. They were fine. I disconnected the null pixel without the pixel and inserted a new one. Prop worked like a charm. Not sure why the null pixel went bad. As I said, this happened twice, two different props.
Sent from my SM-T710 using Tapatalk
