Buffer/line driver ...
 
Notifications
Clear all

Buffer/line driver - null pixel without pixel

347 Posts
90 Users
0 Reactions
197.5 K Views
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

Moisture? Overvoltage? Not enough sunscreen?


Reply
rstehle
Posts: 4348
(@rstehle)
Illustrious Member
Joined: 19 years ago

Curious you should mention failures, I had 2 this season also, and they had only been used 1 season.


Reply
Posts: 602
Guest
(@bwinter)
Honorable Member
Joined: 10 years ago

Did you do a post-mortem to determine cause of death?


Reply
MindTrik
Posts: 1542
(@mindtrik)
Noble Member
Joined: 16 years ago

I would suspect a solder blob or a stray wire at the pads. These boards aren't crazy complicated. I get my magnifying glasses on when soldering though because the pads are so close together because of its size and it's EASY to bridge a pad!


Reply
rstehle
Posts: 4348
(@rstehle)
Illustrious Member
Joined: 19 years ago

When I solder mine up, I place the Data line on the bottom of the board. Makes it a lot easier to avoid solder bridges. I then cover them with 1/2" adhesive lined shrink tube. Can't figure out why they would fail..........


Reply
Page 69 / 70
Share: