Low Current AC Cont...
 
Notifications
Clear all

Low Current AC Controller

11 Posts
8 Users
0 Reactions
20.8 K Views
DrWizard
Posts: 48
Topic starter
(@drwizard)
Trusted Member
Joined: 14 years ago
[#50649]

My display uses LEDs almost exclusively. Most channels have only 1 or 2 strings connected, so the current draw is very small. Does anyone make a less expensive AC controller for low current applications? It would seem to me that you could substitute a VO2223 (or similar) opto-triac chip (rated up to 2A) instead of an optocoupler and a big triac and save a few bucks.

I am guessing though, that in the grand scheme of things when you add the cost of all the other components, it doesn't cost that much more to do high current and so probably no-one makes a low current version.


10 Replies
TomL8345
Posts: 1356
(@toml8345)
Noble Member
Joined: 15 years ago

DirksCheap SSR's work great for your prescribed use.


Reply
Posts: 299
(@dcamron)
Reputable Member
Joined: 10 years ago
DrWizard wrote:Does anyone make a less expensive AC controller for low current applications?

Are you looking for a controller or some SSR’s? I have a bunch of SSR’s based on the VO2223A that I need to assemble but those IC’s have gone up to $1 each. I think the MOC3023 is a more cost effective approach for a 1A triac. They’re 1/2 the cost. Renard Shop used to sell an LCC-16 controller with VO2223’s on board but that’s at least $16 just for the TRIAC’s.

I have a Wireless Renard/DMX in the works that uses an ESP32, MOC3023’s and an enclosed Buck. The goal for that design is a cheaper, low power controller with a small part count. It should come in at half the cost of current Renard designs.


Reply
DrWizard
Posts: 48
Topic starter
(@drwizard)
Trusted Member
Joined: 14 years ago
dcamron wrote:I have a Wireless Renard/DMX in the works that uses an ESP32, MOC3023’s and an enclosed Buck. The goal for that design is a cheaper, low power controller with a small part count. It should come in at half the cost of current Renard designs.

I am VERY interested in this, please keep me informed! I have been debating building one based on the STM32 or Mega2560 because they have plenty of GPIO pins and libraries are available to handle most of the programming. I'm also a big fan of ESP32 but it doesn't have alot of GPIO. How would you handle a high channel count, shift registers?


Reply
Posts: 29
(@jaysdisaster)
Eminent Member
Joined: 11 years ago
dcamron wrote:Are you looking for a controller or some SSR’s? I have a bunch of SSR’s based on the VO2223A that I need to assemble but those IC’s have gone up to $1 each. I think the MOC3023 is a more cost effective approach for a 1A triac. They’re 1/2 the cost. Renard Shop used to sell an LCC-16 controller with VO2223’s on board but that’s at least $16 just for the TRIAC’s.

I have a Wireless Renard/DMX in the works that uses an ESP32, MOC3023’s and an enclosed Buck. The goal for that design is a cheaper, low power controller with a small part count. It should come in at half the cost of current Renard designs.

Please keep us updated I would be interested in a low cost esp32 based controller also.

Sent from my SM-T580 using Tapatalk


Reply
Page 1 / 3
Share: