No, it can also be a bad LED or a contact. Get a LED Keeper from Home Depot.
I have run 12V pixels at 12 volts, do not know the max you could at that voltage, intensity will be lower.
Add a photo of the boards so we can see the chips and design.
Put him in for the Darwin Award.
Well pin 2 works but it looks like I need a level shiftier as the 3.3v signal is too low. Output seems to be RBG but is correct on the V3.0 firmware ...
angus40 wrote:Default is Gpio pin 2 = D4 Thanks will try that. Dennis
Just used the Code and put it on a NodeMCU 8266. Which data pin do you use? Dennis
Good video. Guess I need to update all my ESP-01's now. Dennis
wilmar wrote:Dennis your chart wasn’t showing when I posted mine sorry for doubling up Sent from my iPhone using Tapatalk It happens some times. ...
Waterproof is a generic term. It does not tell you how resistance it is to certain conditions. Take a look at the actual levels of waterproof called ...
Sold
Will sell it for $20.00. Need your zip code for postage cost. Dennis
You are correct. Set each ESPixelstick to one of the reserved IP addresses.
