I currently have a 5X6 P10 matrix and want to down size a bit. Thought it might be a good time to upgrade to P5 panels too.
Looking on Ray Wu's site the waterproof panels sound interesting. What does waterproof really mean?
I am assuming the front of the panel is the only part thats waterproof - no need for a front protective panel I guess.
Do you have to seal between each panel somehow (or is there a gasket of some sort) to help seal things up?
And of course sealing up around the edges and back is given.
Waterproof panels come with a gasket that seals the back of the panel to a flat mounting surface. The front of the panel is designed for exterior use. The surface you are mounting to needs to be flat and relatively rigid to ensure a good seal. It also needs well located holes for screws and locating pins. The screw and mounting pin locations are surrounded by the seal. Each panel seals independently to the mounting surface so no need to try to seal between panels.
Waterproof is a generic term. It does not tell you how resistance it is to certain conditions.
Take a look at the actual levels of waterproof called IP rating. Always look for the rating, if none then "Buyer Beware"
http://www.dsmt.com/resources/ip-rating-chart/
Look for around IP-65 IMHO.
Dennis
Personally when I deal with IP ratings I try for the ip68 as Ive worked in hydro blasting for over 32 years
6 is highest for solids and 8 is highest for liquids... here’s a chart to help with ratings.

Sent from my iPhone using Tapatalk
Thank you!
Covewi
Dennis Cherry wrote:Waterproof is a generic term. It does not tell you how resistance it is to certain conditions.Take a look at the actual levels of waterproof called IP rating. Always look for the rating, if none then "Buyer Beware"
http://www.dsmt.com/resources/ip-rating-chart/
Look for around IP-65 IMHO.
Dennis
Dennis your chart wasn’t showing when I posted mine sorry for doubling up
Sent from my iPhone using Tapatalk
There's really no such thing as waterproof where I am. During the day, sun warms up the electronics and when night comes and things cool down, interior condensation occurs inside everything that's closed, even if it's been carefully "sealed." Best thing to do is mount things vertically and provide a drainage route for the water.
wilmar wrote:Dennis your chart wasn’t showing when I posted mine sorry for doubling upSent from my iPhone using Tapatalk
It happens some times.
Dennis
By the time you build a re enforced metal box for the "waterproof" panels, you might of as well build an enclosure with a plexiglass or lexan front.
The other issue is while everyone has "IP ratings", I seriously doubt that any of them have ever really tested their gear, and I doubt that they test each lot. Most of these devices are low cost hand assembled devices from China.
Caveat emptor!
jklingert wrote:By the time you build a re enforced metal box for the "waterproof" panels, you might of as well build an enclosure with a plexiglass or lexan front.The other issue is while everyone has "IP ratings", I seriously doubt that any of them have ever really tested their gear, and I doubt that they test each lot. Most of these devices are low cost hand assembled devices from China.
Caveat emptor!
And the waterproofing degrades over time. Silicon sleeves are great but you need to refresh the seals at the ends. I have seen many bullet nodes have the sealant shrink after exposure to the sun and a brown streak shows the path of water intrusion. Just assume you are going to need to reseal your pixels every few years.
