Question on 12v pix...
 
Notifications
Clear all

Question on 12v pixels

5 Posts
4 Users
0 Reactions
1,761 Views
kk6ou
Posts: 108
Topic starter
(@kk6ou)
Estimable Member
Joined: 10 years ago
[#53163]

I was just curious if anyone has done a test to see what the minimum voltage it takes to light a 12v pixel. I have an issue with pixels not lighting at the end of a string (RGB are all out). I'm pretty sure it's a configuration issue in my Falcon F16v3 because FPP looks OK. Tomorrow I'll have to connect a laptop into the F16 and check. I know I need to inject power because I measured 7V at the end of the string and it got me to thinking what the voltage requirements are. I would think anything above 5VDC may work since the voltage gets dropped. Not sure if these are resistor or chip regulated and I'm guessing that makes a difference.


4 Replies
Posts: 1387
 kev
(@kev)
Noble Member
Joined: 12 years ago

I have run a half dozen from a 9v battery using a ESPixelstick.


Reply
Posts: 2507
(@mrgrumpy)
Famed Member
Joined: 12 years ago

Depends on the type of 12v pixels. There are resister type and regulator type. Resistor will fade to pink then slight glow of pink before going out. And I have run 12v regulator type @ 5V on test bench.

Likely your start address is off, or you configured too few pixels. This could be in either the sequencer, your input or output of the Falcon


Reply
kk6ou
Posts: 108
Topic starter
(@kk6ou)
Estimable Member
Joined: 10 years ago

I was just curious more than anything. Turns out I didn't add enough pixels in the F16. Fixed that and injected power even though it was running 450 pixels at 30% without a problem. I think these are resistor pixels since it looks like there are 2 SMB resistors on the board.


Reply
Posts: 304
(@dennis-cherry)
Reputable Member
Joined: 19 years ago

I have run 12V pixels at 12 volts, do not know the max you could at that voltage, intensity will be lower.


Reply
Share: