scottmcm wrote:Go into your bin of old light strings and find a chaser set from the 90s. Cut the lights off and wire female plugs onto each of the th...
They are speculating that they are OTP (fuses if you like). Some internals here:
It would be real interesting to see one of these pulled apart. a COB with a bunch of leads to set the address via straps or actually programmed? I wou...
1pet2_9 wrote: I'm in love with them, and my wife feels threatened. Snort. Thank you for that. The LORA approach is interesting too, might get one ...
I've been replacing with the pink LEDS, just not quite right. I wonder if they scrimp on the phosphor, failure rate is way higher than other colors.
I wonder-how close is the "pink" colour ~ 665nm
If you can measure low VSWR at the frequency of interest then you should not be able to harm the transmitter as you are not reflecting the power back....
Another vote for the P touch flag method- have used it extensively for work, holds up well.
Slap a 2x4 horizontally on the inside and outside of that opening going 6 inches past either side of the opening . Use ~3/8 all thread and some nuts t...
Hmm- first thing that pops up if you google PCR406J:
The OP said some lights were on constantly ( please correct me)?but We only have 3 wires total on the output side that I observed? I now wonder if th...
I would not be surprised if under the blob was a HL2202LF, they just use an RC for timing and support 1,2,3 or 4 strings: asian site -
That K1851D is likely a 2SK1851 DS : The 2SK1851 is N-channel MOS Field Effect Transistor designed for solenoid, motor and lamp driver. Maybe the ot...
That is a vertical pcb with a blob -ie chip on board ? Jim already mentioned this Suspect that was the switching logic, guessing only two "string set...
Kensington wrote:I bought a bunch of 12v 400w generics this year for a total of $100. What a deal! But when they showed up, they were 170-220v, even...
