sporadic wrote:I see a couple of deltas from my config, not sure it would be causing your issues though. One thing you may want to try is turning on ...
aaa.1.br.devname=br0 aaa.1.devname=ath0 aaa.1.driver=madwifi aaa.1.radius.acct.1.status=disabled aaa.1.radius.auth.1.status=disabled aaa.1.radius.maca...
Well, I'm about to give up on getting things in sync this year. I've stripped things down to just a handful of pixel sticks (5 of them, about 10 feet ...
darko886 wrote:Thank you for that, I'll do the same then. And the board can be powered by the USB port right? At work and haven't had a chance to test...
I used a 23AWG strand of wire about 30 inches long (a piece of a Cat5 cable I cut up). Just soldered it into the hole marked "ANT". Works great out to...
jchuchla wrote:remember that the nslm2 is a highly directional antenna, so it's going to find things a lot farther than a normal AP would see. Though...
jchuchla wrote:oh. here's another Idea. Do you have your espixelsticks set to the right number of pixels each? When i originally set mine up, i had...
Woah, my NSLM2 is picking up a lot more networks than I expected... MAC Address SSID Radio Mode Encryption Signal ...
jchuchla wrote:so you're talking only 9 universes? 16 right now total. 9 for the tree and its star.
So, I added back in my megatree (four controllers with 240 pixels each) and things still looked good and synchronized. I then jumped straight to power...
Success! Sort of... Right now I have my NSLM2 and laptop connected to a Motorola WR850G (same as Linksys WRT54GL). Only one ESPixelStick is powered o...
sporadic wrote:So FPP and the NSLM2 AP are connected through the D-Link switch? Do you have a dumb switch you can test with? I might have gotten rid...
MikeKrebs wrote:you seem to have a few computers available. can you capture the packets out of the source and on the end? compare timestamps on the t...
jchuchla wrote:man you got me thinking about this one. So your FPP file originated from xlights and they're both showing the problem? Could it be an...
jchuchla wrote:ok, you've got a tough one here. This shouldn't be this difficult. Is the audio/sequence delay consistent or does it vary between 2 a...
