Activity
 
Notifications
Clear all
cmitcham
@cmitcham
Reputable Member
Joined: Dec 4, 2008
Topics: 21 / Replies: 190
Reply
RE: ren64 + ssr bare boards

pending with 1st pm responder...

6 years ago
Topic
Replies: 2
Views: 1188
Reply
RE: Renard 24HC channel stuck on

can you assemble enough extension cords to plug the suspect wireframe into a switched receptacle inside your house and see if it is on when you turn t...

7 years ago
Forum
Reply
RE: portable hole trouble

jchuchla wrote:...and i cringe every time. thanks, good to know. from now on, i'll place the hole and hold the pipe vertical while i thread it in 🙂

7 years ago
Forum
Topic
Forum
Replies: 8
Views: 6915
Reply
RE: WTB pixel controller that's compabitable w/Renard

falcon player can serve sequences to a pixel controller and renard at the same time

7 years ago
Reply
RE: Any wirless AC SSR options for Renard 64?

LOI??? something something insurance?

7 years ago
Forum
Reply
RE: SanDevices version 5 firmware information thread

jim hasn't logged in here since june. is san devices going to continue? i hope so mainly because i like building my stuff myself, but i'm concerned. w...

8 years ago
Topic
Forum
Replies: 1
Views: 4435
Reply
RE: WTB Renard SS24

I have 2 ren24 available. they are not the ss24, but the older ren24. the both work fine. pictured at $90 - bare ren24 $100 - ren24 in cg1500. plus...

8 years ago
Reply
RE: Back to step one writting a hex file to 16f688

i followed the pololu example to step11 where they make a main.asm. i cut/pasted the renard asm code into there.maybe wayne's trick is easier???

8 years ago
Forum
Reply
RE: Back to step one writting a hex file to 16f688

back in november (post#5) i lied when i said i had done this before with mplab x. i finally found this tutorial at pololu and was able to make a hex f...

8 years ago
Forum
Reply
RE: E682

is the new computer on the right network?

8 years ago
Reply
RE: My show is down! I can't figure out why my boards won't work.

is the ac power to the renards ok? are the power leds lit?

8 years ago
Forum
Reply
RE: access 682 webserver on show network

wow, easy-peasy... turn off the wifi on my pc, set the ethernet to any static show network address, plug cable from pc to 682 and there it is. i was...

8 years ago
Page 1 / 15
Share: