Activity
 
Notifications
Clear all
cmitcham
@cmitcham
Reputable Member
Joined: Dec 4, 2008
Topics: 21 / Replies: 190
Topic
Reply
RE: Popping Circuit Breakers When Hooked Up to USB

i guess then that the triacs must be bad, but i would like to hear from someone more knowledgeable than me. all 13 other channels are fine? you have ...

8 years ago
Forum
Reply
RE: Popping Circuit Breakers When Hooked Up to USB

dang. worst case, you have a 13 channel show this year. switch the channel 1 and channel 2 moc chips and see if the problem moves from channel 2 to c...

8 years ago
Forum
Reply
RE: Popping Circuit Breakers When Hooked Up to USB

patmitchell wrote:Yes, I have the board in it’s box mounted with two screws. Just tried with pigtail on channel one removed and it zapped my last fus...

8 years ago
Forum
Reply
RE: Popping Circuit Breakers When Hooked Up to USB

patmitchell wrote:I put pig tails on channel 1 and 2 and tested and the power led flashed on and then the fuse blew. So I have a problem in channel 1...

8 years ago
Forum
Reply
RE: Popping Circuit Breakers When Hooked Up to USB

i guess try it with pigtails and light strings! be slow and cautious, don't let a pigtail leave a stray wire sticking out, etc

8 years ago
Forum
Reply
RE: Popping Circuit Breakers When Hooked Up to USB

patmitchell wrote:It was. I went into Vixen 3.0 and set up the usb connection as the vixen site directed and then I clicked ok. The moment I clicked...

8 years ago
Forum
Reply
RE: Popping Circuit Breakers When Hooked Up to USB

the #1 resistor and moc were toast and replaced. the triac is fine. an attempt to remove moc socket #16 tore up 2 traces, but were fixed. board tested...

8 years ago
Forum
Reply
RE: Popping Circuit Breakers When Hooked Up to USB

yikes pat, this is bad. we can't lose you at this point, and time is getting short... this board worked perfect for me, all 16 channels blinked and d...

8 years ago
Forum
Reply
RE: Bad batch..

are we talking about moc3023? I am about to populate 32 ssrez boards still sitting here, and after 10 years running 5 ren24 without ever replacing a s...

8 years ago
Forum
Reply
RE: Need Help, unit not powering on

if i had sockets backwards, i would just leave them, but make double sure you put the chip in correctly. pm me your address, and i can send you a 6 pi...

8 years ago
Forum
Reply
RE: kostyun ren24 for sale

i still have 2 left

8 years ago
Reply
RE: Back to step one writting a hex file to 16f688

i'm not quite following you. i am in the same boat, and need to program some renard chips in the next couple weeks, not having done so for several com...

8 years ago
Forum
Reply
RE: wtb renard 24 channel

still available...

8 years ago
Reply
RE: Renard controller!

check out these links. the ren24 board works great, and i can help you get started with it.

8 years ago
Forum
Page 2 / 15
Share: