Activity
 
Notifications
Clear all
CatMan42
CatMan42
@catman42
Reputable Member
Joined: Jan 27, 2015
Topics: 18 / Replies: 345
Reply
RE: p5 Matrix issues using FPP and xLights

Hey Guys, Just thought I'd do a quick follow up on the matrix issue. All the problems were in the configuration of FPP. And cmndr brain, you were rig...

5 years ago
Reply
RE: p5 Matrix issues using FPP and xLights

Duh, totally forgot about the zoom room. Thanks for the reminder!

5 years ago
Reply
RE: p5 Matrix issues using FPP and xLights

Come on guys. 7 days to showtime. I've tried everything I know. This has got to simply something I'm over looking.Multiple eyes on the problem are bet...

5 years ago
Topic
Replies: 8
Views: 2471
Reply
RE: Help!!! 32 Channel with Random option but no dimming

"As for Questions for you guys, I am looking at this thread that you posted CatMan, It had a build of the zero cross and uses a specific sketch. You...

8 years ago
Forum
Reply
RE: Help!!! 32 Channel with Random option but no dimming

xGROMx wrote:Digging up an old thread. I just replaced a few 202P's to 202PL's on a sainsmart board. I was expecting to test a dimming wave on vixen...

8 years ago
Forum
Reply
RE: DIGWDF Store Announcement

Being a supporter of Dave's store and having built almost all of his boards (like the RenZilla and over 100 DirkCheap SSR's), I am extremely sad that ...

8 years ago
Reply
RE: Cause Ribbons by Boscoyo Studio

Duh, too obvious to figure out!!:wow: Thanks Wolfie!!

10 years ago
Reply
RE: Cause Ribbons by Boscoyo Studio

Wolfie wrote:Here is an alternative effect sequence. This has ONLY the ribbon with the 12mm matrix (not the p10) since thats the one I am focusing on...

10 years ago
Reply
RE: How do you set up supports in 3d?

Whew, spent most of the day working with supports for overhangs. Finally have it figured out. In Slicer, go to "configuration", then under "support ma...

10 years ago
Reply
RE: How do you set up supports in 3d?

Thank you for pointing me in the right direction!! It can get a little crazy when you're trying to learn something new while trying to get your light...

10 years ago
Reply
RE: How do you set up supports in 3d?

here's the other issue I have, Even though I've calibrated the print table numerous times, I get un-even printing. My thought is not enough flow. Is t...

10 years ago
Reply
RE: How do you set up supports in 3d?

I actually saw that and tried it to no avial. I'll read through it again. More than likely I missed something!! Thanks!!

10 years ago
Page 1 / 25
Share: