Amazing!!!
HEMISixty wrote:Casper, could you reference the post number and thread of the sketch you use or, if yours is different, post it, please? With 29 page...
Ok here's some info that I hope helps Some others. Since I have had years to narrow this down 🙂 and this is from my experiences I load my sequence f...
Re: Easy to use code for Arduino Uno/Mega. Up to 48 channels, with Random mode I looked through the whole thread but i didn't see anything else but t...
Hey Tomas, I have a Mater/Remote setup. I have my master running all the pixels on the outlines on my house and I have a PI remote on the lawn that I ...
this code? /* The purpose of this code is to allow the Arduino to use the generic serial output of vixen lights to control 5 channels of LEDs. Author...
MartinMueller2003 wrote:You just need a better sketch. A lot of people grab this sketch and another from Victor. They both have the same major flaw an...
MartinMueller2003 wrote:The code in general has a major flaw. It does not have any header processing and will often not do what you expect. I totall...
Re: Easy to use code for Arduino Uno/Mega. Up to 48 channels, with Random mode Just 16 off the mega then I have about 1000 pixels on the house, Its s...
Re: Easy to use code for Arduino Uno/Mega. Up to 48 channels, with Random mode Here is a screen capture Sent from my SM-G960W using Tapatalk
So I just reloaded the sketch into the Mega, then rebooted everything and now I hear relays clicking. I'm not sure if they are the right ones, I'll fi...
MikeKrebs wrote:The header fields are required for the sketch to work. Did you by chance enable dimming on your channels? The sketch is looking for le...
kev wrote:The sketch has that code in it already. uno is looking for ~ and dos is looking for ! . if (uno == 126){ int dos = Seria...
But do the headers have to be in the sketch too? for instance if I use ~! as a header, is there code that should be in the sketch for this?
