Barnabybear
Barnabybear
@barnabybear
Noble Member
Joined: Dec 28, 2011
Last seen: Nov 19, 2026
Topics: 56 / Replies: 1527
Reply
RE: Snowflake Projector Light

Hi Richie, looking at the original circuit board / LED driver (sketch below). The incoming 5V passes through a SS26 Schotty diode. From figure 2 of t...

5 years ago
Reply
RE: Snowflake Projector Light

Hi Richie, google is telling me that an A09T is an N channel MOSFET which means this would have an 80% on duty cycle. This may explain why you could n...

5 years ago
Reply
RE: picap set up

Hi, if you use DMX the FPP settings are: Output type is DMX-Open Output Config Port is ttyAMA0 I recently had to look around for them the documentat...

5 years ago
Reply
RE: cutting RGB 2811 pixels? question

Hi, with regard to the data between pixels. You’ll never go far wrong setting out the distance between strings in a similar location and then a longer...

5 years ago
Forum
Reply
RE: Fault finding a switch mode power supply.

Hi David, yes this was interesting. For the younger amongst us when I did my apprenticeship back in 1980 this would have been nearly impossible to fix...

5 years ago
Reply
RE: Fault finding a switch mode power supply.

Hi Angus, the Zener supplies the diode side of a feedback opto-coupler. As far as I can see it just drops the 24V down to 12V and is only passing abou...

5 years ago
Reply
RE: Fault finding a switch mode power supply.

Hi, well this has been a fun project – incredibly frustrating and taken up more time than the supply is worth BUT IT’S WORKING! Sorry for the caps bu...

5 years ago
Reply
RE: Fault finding a switch mode power supply.

Hi David, thanks for that advice. I’ve been through the board again a couple of times and compared the resistances and capacitances at nearly every p...

5 years ago
Topic
Replies: 10
Views: 3730
Reply
RE: HiLetGO 12F

P. Short wrote:OK, I was able to run a "Hello, World" sketch on that board without any need to play with GPIO0. Now I have to see if I can replicate ...

5 years ago
Forum
Reply
RE: HiLetGO 12F

Hi Phil, I haven’t found a picture or schematic for the HiLettgo module so I can only offer some general background and my well state the obvious (ple...

5 years ago
Forum
Reply
RE: Phil's Dimmer

Hi Phil, it has been reported that the ADC can return very slightly inconsistent results when measuring a fixed constant voltage such as a cell with n...

5 years ago
Forum
Reply
RE: Phil's Dimmer

Hi Phil, if you want to blink an LED at 1Hz across ten different processors the Arduino IDE is brilliant but slow. Not a problem with faster processor...

5 years ago
Forum
Reply
RE: Phil's Dimmer

Hi Phil, whilst the ATMega’s and the ESP can be programmed through the Adruino IDE they are very different when you come to writing to registers. I’ve...

5 years ago
Forum
Reply
RE: finally back in christmas mode E682 firmware

angus40 wrote:Wasn't the upgrade only required for the e681 to increase from 4 to 12 universes etc ? Hi Angus, I need to pick your brains about movi...

5 years ago
Page 3 / 106