Ahh.. OK then... Better ignore my advice! Excuse me as I put some sunscreen and sunglasses on to finish putting my lights on... its 08:30 and its exp...
rklarman wrote: Some of the time it is the solder pads that seem to get oxidized. Other times it is the Cat5 jack and/or rj45 plug. Solder is (ofte...
Thought about a squirrel-cage blower motor (ie from a heater) Might push a bit of air your looking for and available post-new 🙂
Just an addendum: I used wire shark to establish why my e1.31 controller was not receiving vixen 1.31 data. Turned out the switch that I was using was...
I use But there are other apps around like wire shark that I've used. Hope this helps
Ta.... Just heading into Exam time right now.. but this is firing up Nov1 so that will be the first thing I will try. FWIW: My eventual goal is to ta...
Great work! When I verify - with all libraries installed, I get a compile error: C:\Documents and Settings\michael\My Documents\Arduino\libraries\Ada...
I have two 1.1 boards, one SP485ES and two eeproms here. Your welcome to them for cost + delivery from Australia. I bought a prebuilt unit from RPM p...
Mate.. She's ready for negotiation! As you will learn once married you'll need to fight for every one of those opertunities! I recommend you negotiat...
Geez... "now my new problem is talking the wife into letting me spend the $$ on the ssr parts" + "ordered a PICKIT2" and YOUR NOT EVEN MARRIED YET!! (...
I read somewhere that EL lighting -being based on phosphor - will break down with UV light and dramatically reduces its lifetime when left out for a c...
wouldn't RGB move this from being "affordable"? The PCBs would be 3x the size.. the controller 3x the price.. Be "interesting" to program as well - ...
I had seen a similar setup too... be pretty cool if you could add a UV addative to the fluid! Here is a link I was looking at one that claim it won't...
Lots and Lots of dry ice (compressed CO2) might do the trick - or a stack of mineral-based smoke makers (although it would be pretty "noisy"!)
