2015 Bethlehem Star
 
Notifications
Clear all

2015 Bethlehem Star

117 Posts
15 Users
0 Reactions
44.4 K Views
IaRoadKill
Posts: 586
Topic starter
(@iaroadkill)
Honorable Member
Joined: 12 years ago

I was just at Home Depot and forgot to look at zip tie guns!


Reply
IaRoadKill
Posts: 586
Topic starter
(@iaroadkill)
Honorable Member
Joined: 12 years ago

I'm getting there...

image

Reply
IaRoadKill
Posts: 586
Topic starter
(@iaroadkill)
Honorable Member
Joined: 12 years ago

Ok. Top and bottom points have lights on them. 8 strings of 50.
POOP! The lights do not dim well. They pause off at the start and then stutter and ramp up fast as the the curve goes up.
I hacked the plug and recepticle and found capacitors in them. I thought I bought dim able lights, but they were just full wave.
I'll need to remove the capacitors.


Reply
IaRoadKill
Posts: 586
Topic starter
(@iaroadkill)
Honorable Member
Joined: 12 years ago

I have my Ren32 built and all checked out.

I had planned to use the small Renzilla SICSSR's on each string but it seems that the SICSSR is only for on/off and no dimming. Can anyone confirm this?

TazChaLet, I'm reposting my problem and pictures here since the Ren32 is ok.

image
image

For communication from the Ren32, I wired the cat5 from the top side (clip side, right to left) :

image

O/W - not used (should be pin 1, the square solder pad)
O - ch1
G/W - not used
Bl - ch2
Bl/W - not used
G - ch3
Br/W - signal ground
Br - ch4

I need the smallest dim-able SSR i can find. ( I need 32 of them)


Reply
Posts: 4092
(@skunberg)
Famed Member
Joined: 18 years ago

Go to the library and look up chasecicles. There's directions for a small single channel SSR from breadboard.


Reply
IaRoadKill
Posts: 586
Topic starter
(@iaroadkill)
Honorable Member
Joined: 12 years ago
Skunberg wrote:Go to the library and look up chasecicles. There's directions for a small single channel SSR from breadboard.

I was thinking about that.

Can I substitute an H1AA11 for the moc?
(Looks the same)


Reply
Posts: 4092
(@skunberg)
Famed Member
Joined: 18 years ago

Out of my ability to substitute parts.


Reply
IaRoadKill
Posts: 586
Topic starter
(@iaroadkill)
Honorable Member
Joined: 12 years ago
Reply
Posts: 2541
(@lightup)
Famed Member
Joined: 17 years ago

Both circuits can do dimming.
Current rating for the 1st one is 1A, the 2nd one I didn't know which triac was used so can't say its current rating.


Reply
Posts: 4092
(@skunberg)
Famed Member
Joined: 18 years ago

I don't know anything about Dirks board, I would think it would dim but I'm not the one to ask. The latter breadboard ssr does dim.


Reply
Page 3 / 12
Share: