Moving elements to ...
 
Notifications
Clear all

Moving elements to different controller - preserve sequence

6 Posts
4 Users
0 Reactions
1,734 Views
Posts: 59
Topic starter
(@arange98)
Trusted Member
Joined: 12 years ago
[#47744]

I have a few elements that would be easier to wire if they were on a different controller, but I would prefer to not have to rework my existing sequences. I can't seem to figure out how to "move" the output to a different controller without it impacting my sequences...

For example : Move elements assigned to first controller outputs 3,8,12 to second controller outputs 10, 11, 12

I'm sure it's not that hard, but could use a little guidance.

Thanks,
Allen


5 Replies
StickyWicket
Posts: 548
(@stickywicket)
Honorable Member
Joined: 14 years ago

Sequences shouldn’t be impacted by controller configuration.

In Display Setup you can unpatch an element and then patch it to a new one.

Perhaps a few pictures of your setup and/or a quick video of what your trying to do would help us help you.


Reply
Posts: 59
Topic starter
(@arange98)
Trusted Member
Joined: 12 years ago

Here are images of my current setup, desired setup, and a sequence. I think I can remove the patching for an element (say upper roofline) and then repatch it to the desired output. But will that leave my sequence intact and change the output switching to the new output on my second 24ch controller?

Thanks again for having a look at this one.

image1
image2
image3

Reply
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

you select the element on left side click the box below to find what it is patched to then click unpatch on the right side then select where you want it patched and repatch it


Reply
jchuchla
Posts: 8698
(@jchuchla)
Illustrious Member
Joined: 15 years ago

Yes, just unpatch the elements and repatch them where you want them to go. The sequencing is tied to the elements and their grouping. So don't delete elements, or their groups if you have sequencing on the groups. Just unpatch and repatch.


Reply
Posts: 59
Topic starter
(@arange98)
Trusted Member
Joined: 12 years ago
TazChaLet wrote:you select the element on left side click the box below to find what it is patched to then click unpatch on the right side then select where you want it patched and repatch it
jchuchla wrote:Yes, just unpatch the elements and repatch them where you want them to go. The sequencing is tied to the elements and their grouping. So don't delete elements, or their groups if you have sequencing on the groups. Just unpatch and repatch.

Wow! Thanks for the clarification. That was easy - I guess I was overthinking things. LOL

Cheers,
Allen


Reply
Share: