Refresh Timing
 
Notifications
Clear all

Refresh Timing

15 Posts
4 Users
0 Reactions
5,207 Views
jchuchla
Posts: 8698
(@jchuchla)
Illustrious Member
Joined: 15 years ago

Yeah, that's one of the magic compromises we made on the 3.1 release that makes sequencing more tolerable for high channel count users. The controllers use a lot more overhead than the preview. So this definately helps for sequencing. If you have the problem on the opposite side you have the option of exporting sequences for playback on xlights or fpp.

--Jon Chuchla--

Sent from my iPhone using Tapatalk


Reply
Posts: 322
Topic starter
(@rklarman)
Reputable Member
Joined: 18 years ago
jchuchla wrote:Yeah, that's one of the magic compromises we made on the 3.1 release that makes sequencing more tolerable for high channel count users. The controllers use a lot more overhead than the preview. So this definately helps for sequencing. If you have the problem on the opposite side you have the option of exporting sequences for playback on xlights or fpp.

--Jon Chuchla--

Sent from my iPhone using Tapatalk

I tried to use xLights but the effects didn't appear to transfer properly. I didn't have much time for troubleshooting so I went back to V3 for this year.


Reply
jchuchla
Posts: 8698
(@jchuchla)
Illustrious Member
Joined: 15 years ago

When that happens it's almost always a controller order or channel count mismatch between the setup on the two programs. It's best to troubleshoot later at this point. But what you need to look for is that your controllers and universes are the same size on both systems and that the controllers are in the correct order on the export screen.

--Jon Chuchla--

Sent from my iPhone using Tapatalk


Reply
Posts: 12
(@cdnbob)
Active Member
Joined: 12 years ago
jeffu231 wrote: ... That tells me that it is missing parts of the data because the pulse length is to long compared to the effect length and number of elements. ...

Jeff

Can this be calculated when creating sequences so you can get to the right balance readily? Right now I do trial and error, which takes time and sometimes I don't get to a satisfactory solution (when I have to change something too much for the desired effect). If I could calculated the needed parameters up front it could save some time.

Bob


Reply
jchuchla
Posts: 8698
(@jchuchla)
Illustrious Member
Joined: 15 years ago

In theory you could. But it's complicated. That's probably why we haven't yet put in the code to check it.

--Jon Chuchla--

Sent from my iPhone using Tapatalk


Reply
Page 3 / 3
Share: