Scheduled a sequence to run at 5pm till 6:30. The "Show" program was scheduled to run at 6:30.
The 5pm sequence ran fine but the 6:30 scheduled program failed to start and threw a small number of error's. In my haste to get up and going I did not capture the errors. One was saying there was a com error another said a key was missing.
I am running on version 2.5. Any thoughts?
My guess is program #1 was not fully finished before program #2 attempted to open the port and the "hold it open for the duration" option is selected as the plugin allows us to do.
Same issue I am having with 2.5. I suggest going back to 2.1 for your show computer and just copy paste your sequences over. The 2.5 sequences work in 2.1.
Like Virtus said, I'm guessing the first show isn't done running. When the schedule goes to 6:30, it means it won't start the program after that, but it doesn't kill the program that is running, it just waits until it is done. For example, my 15 minute show is scheduled to turn off at 10:00, but the last program starts at 9:55 so the show really ends at 10:10. If you put some more time between shows it should work. I'm using 2.5.0.8 and is has been rock solid (in the third night now).
holtm wrote:Like Virtus said, I'm guessing the first show isn't done running. When the schedule goes to 6:30, it means it won't start the program after that, but it doesn't kill the program that is running, it just waits until it is done. For example, my 15 minute show is scheduled to turn off at 10:00, but the last program starts at 9:55 so the show really ends at 10:10. If you put some more time between shows it should work. I'm using 2.5.0.8 and is has been rock solid (in the third night now).
I was thinking along the same lines. I will adjust the first program to be done before the second one starts and see if that cure's it.
Thanks all!
