Modifing Snowflake ...
 
Notifications
Clear all

Modifing Snowflake Icicles???

4 Posts
3 Users
0 Reactions
2,498 Views
(@rrowan)
Posts: 134
Estimable Member
Topic starter
 
[#2074]

Hi Folks,

The wife just loves these snowflakes. So they have to be on the house.
I would love to cut off the controller board (they are lousy controllers) and wire it up to a couple ssr boards.

There are 9 flakes per set. They are in groups of 3. There is four wires coming out of the male plug - 2 wires go to the female plug and 2 go to the controller box. There are 4 wires coming out of the controller - one common and one for each group. The box says 2.5 volt blubs and there are 50 lights per group.

So has anybody take these apart and wire them up for Vixen control?

Any help / info will be greatly appreciated.

Thanks

Rick R.


Grinch 64 - Built and tested on Jan 22, 2008
Lynx Express, Lynx, SSR4, SSR4-DMX, MR16, DMX Splitter, FreeStyle

So far no burnt fingers (but there is still hope)

 
Posted : 06/01/2008 1:42 pm
(@jwells)
Posts: 56
Trusted Member
 

So each group has 3 snowflakes correct ? if each group is controlled by 2 wires then you most likely can cut that and run each group individually. Seems like each group has 50 lights X 3 =150 The controller is wired to each group of 3 most likely not sure how they are using the 4th output on the controller. Yes you can remove it I have done so with other setups myself.

Jim


 
Posted : 06/01/2008 4:05 pm
PacMang
(@pacmang)
Posts: 241
Reputable Member
 

I got the same ones.. was just going to use them as is.. but if we can figure out a way to cut them that would be awsome...


448 Total Channels over 100,000 lights (2010)
256 Channels on 4-Ren64XC's (dimmable)
192 Channels on 8-Ren24ss (dimmable)
www.tallahasseelights.com

 
Posted : 06/01/2008 7:40 pm
(@rrowan)
Posts: 134
Estimable Member
Topic starter
 
jwells wrote:So each group has 3 snowflakes correct ? if each group is controlled by 2 wires then you most likely can cut that and run each group individually. Seems like each group has 50 lights X 3 =150 The controller is wired to each group of 3 most likely not sure how they are using the 4th output on the controller. Yes you can remove it I have done so with other setups myself.

Jim

Yes each group is 3 flakes. 50 lights per group for a 150 total.

Snowflakes are group like this.
1 2 3 1 2 3 1 2 3

4 wires - I think one is common and then one wire per grouping.

We got more snowflakes lights so I can experiment with an older set. The wind this year really beat them up.

mgrosh - I'll keep posting here my findings.

Thanks

Rick R.


Grinch 64 - Built and tested on Jan 22, 2008
Lynx Express, Lynx, SSR4, SSR4-DMX, MR16, DMX Splitter, FreeStyle

So far no burnt fingers (but there is still hope)

 
Posted : 06/01/2008 10:12 pm
Share: