wow the last pic was it... it seemed to work (all its own channels flashed correctly) however, it was not passing the data along. I checked it in ...
the jack looks perfect. and the traces look fine (although its hard to ever see any issues with traces) i was hoping for some test to tell if its t...
ok with more testing i narrowed it down.. ONE of my ren64s is the problem. no matter what i put after it (ren24 or ren64) it does not pass any da...
good idea. i made a ren24 the first controller from the computer (using rs232) and pluged another ren24 as the second via rs485 and they both worked...
I would be to. however, I can run a cat5 from the first ren64 to another ren64 (which works) and then take that same cable and plug it into (3 diffe...
there isnt. and if i take the same cat5 and plug it into another ren64 i see the leds light up for my test sequence(on the 2nd ren64). so i know i ...
yes i swapped both of those (with each other) how would i know if both were bad?
test with short piece of wire.. worked. soldered a jumper from pin5 of the oscillator to pin 2 of one of the pics. full diag worked on all channe...
ok thanks, since all the pin2's are reading the same it must be this trace that is bad (in yellow). correct? if it is, what would you suggest to fi...
not sure which one is pin 5 on the oscillator but the 2 pins with a voltage read 2.5v and 5.0v pin 2 of every PIC socket (with the Diag chips still i...
i have started a new thread to try to make things simpler. that for all the help. as of now i have all 8 PIC working with the diag with internal os...
well I probably counted the pins wrong i couted like 1 2 3 4 5 6 7 8 9 10 11 12 13 14 so 8-14 are flipped. 14 is reading zeroill ...
