Notifications
Clear all
Jan 02, 2022 6:19 pm
MartinMueller2003 wrote:25' using a reasonable quality cable (aka not speaker wire or zip cord) with power injection at the first pixel is not very far at all. Worst case would be adding a buffer/driver at the 15' point inline with the data and V- wires.
I probably will be in the same situation next year. Why not zip cord? I have 18/2 Corrowire SPT-2 which according to my understanding are pure copper. Wouldn't that be sufficient for a 25' run to provide power?
Jan 02, 2022 8:06 pm
munu wrote:I probably will be in the same situation next year. Why not zip cord? I have 18/2 Corrowire SPT-2 which according to my understanding are pure copper. Wouldn't that be sufficient for a 25' run to provide power?
For data, the wire gauge is not very important and SPT wire insulation is not good against noise. You want to have data nad v- twisted around each other for noise reduction (cmr). CAT5 does this for you in the wire pairs.
Jan 02, 2022 9:00 pm
Thanks for the feed back. Searching I found this calculator http://spikerlights.com/calcpower.aspx to help answer some of my questions about power injection and voltage drop.
Page 2 / 2
Prev
