Notifications
Clear all

SSR failures

11 Posts
6 Users
0 Reactions
22.2 K Views
Posts: 844
Topic starter
(@ags0000)
Noble Member
Joined: 16 years ago
davros wrote:What brand is the SSR? Many units with false specs out there.

Potter & Brumfield (apparently now part of TE). It served without issue for 4 years, but with less load. The single cycle surge spec is 250A, which reinforces my suspicion. I found an "NTE" branded SSR at Fry's with 50A on-state current and 450A single-cycle surge and installed that. I then setup a test to cycle it on/off every 5 seconds for 30 minutes, and no failure. There are other 50A SSRs available with 750 and 900A single-cycle surge rating, which I'll prefer and possibly upgrade to to be further from a failure in the future.


Reply
Posts: 3735
(@algerdes)
Famed Member
Joined: 15 years ago
ags0000 wrote:...The single cycle surge spec is 250A,...

Can you explain this "single cycle"? Not familiar with it. Thanks.


Reply
Posts: 844
Topic starter
(@ags0000)
Noble Member
Joined: 16 years ago
Barnabybear wrote:Hi, the link below is a teardown of a 25A SSR, 4:40 looks at the triac.

This was very informative - particularly the issue of fake components on eBay and in this case, the potential for a real hazard. I strongly encourage anyone working with mains voltage to be certain of the legitimacy of the parts used. In the case of this teardown, although rated at 25A on the label, the components were actually only good for approximately 10A.


Reply
Posts: 844
Topic starter
(@ags0000)
Noble Member
Joined: 16 years ago
algerdes wrote:Can you explain this "single cycle"? Not familiar with it. Thanks.

SSRs are spec'd for maximum continuous current and "single cycle" current. The latter is the current sustained through a single cycle (1/120th of a second for 60Hz AC). It is helpful when considering the inrush current when voltage is first applied to the connected load. For example, the Meanwell supplies I am using are rated at just under 7A input current but 60A inrush current.


Reply
Posts: 3735
(@algerdes)
Famed Member
Joined: 15 years ago

Thank you.


Reply
Page 2 / 3
Share: