Purchasing Sequence...
 
Notifications
Clear all

Purchasing Sequences

36 Posts
7 Users
0 Reactions
6,869 Views
Posts: 1065
Posts: 1065
Topic starter
(@olingerjccj)
Noble Member
Joined: 17 years ago

I

ptinhays wrote:
I can check when I'm at the office tomorrow to see what's there. I know there are quite a few PC's that run Windows 10 natively and would work fine for your show. I run my show directly from DE9 to ethernet from the PC to the first Renard, then it converts it to rs485 to each subsequent controller. I'm still using dumb RGB "super strips" as floods on the house that are powered by a Ren48LSD. Still 88 renard channels on my modern show, lol. I bet I have a PCIE serial card that would work on any of the PCs I have too.

Just out of curiosity, what USB to serial adapter are you trying to use? Did Windows get the drivers installed for it correctly?

I Posted a pic not great quality but i posted the actual link down below. Check it out tomorrow I am still messing with it tonight maybe a miracle will happen. Thank you so much.


Reply
rayhjr
Posts: 972
(@rayhjr)
Noble Member
Joined: 12 years ago

So, if you do make the move to Vixen3, which I think you have. Try lookingherefor sequences.


Reply
Posts: 1065
Topic starter
(@olingerjccj)
Noble Member
Joined: 17 years ago
rayhjr wrote:
So, if you do make the move to Vixen3, which I think you have. Try lookingherefor sequences.

I downloaded it but the leaning curve was a bit much so I went back to what I knew


Reply
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

That one does have a tx light. If it is not lit, then nothing is being sent to the wires.

And I have four of them in the basement. They were very reliable for me when I used PX1.


Reply
Page 6 / 8
Share: