Purchasing Sequence...
 
Notifications
Clear all

Purchasing Sequences

36 Posts
7 Users
0 Reactions
6,867 Views
Posts: 1065
Topic starter
(@olingerjccj)
Noble Member
Joined: 17 years ago
ptinhays wrote:
Did you check the com port settings in device manager on that laptop? It has to match the firmware as far as speed and the settings in Vixen in order to communicate properly. If I remember correctly, the port settings should be as follows.

Port settings

Vixen needs to match that too and be set for the correct com port or you won't get anything out of it.


Reply
Posts: 1065
Topic starter
(@olingerjccj)
Noble Member
Joined: 17 years ago

115200 not 57600? I can definitely try it


Reply
Posts: 1065
Topic starter
(@olingerjccj)
Noble Member
Joined: 17 years ago
ptinhays wrote:
Did you check the com port settings in device manager on that laptop? It has to match the firmware as far as speed and the settings in Vixen in order to communicate properly. If I remember correctly, the port settings should be as follows.

Port settings

Vixen needs to match that too and be set for the correct com port or you won't get anything out of it.

I thought we had something there but changed both to match and still no connection


Reply
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

That is an RS 485 adapter. Did you use an ohm meter to make sure the signals are showing up on the correct pins at the Renard end? Did you set the jumper properly to enable the termination resistor?

If those are correct, you most likely need to change the baud rate to 57600 baud (Renard default). However, if the baud rate was wrong and the data pins are correct, the you would be getting the FE led lit indicating a communications signal was received but could not be decoded. I also suggest you set the PC side to 2 stop bits for initial testing. Doing this is OK as long as the receiving side is set to a value equal or lower than the sending side.


Reply
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

Does the adapter have a TXX activity indicator? Can you please post a link to the adapter you purchased.


Reply
Page 5 / 8
Share: