Purchasing Sequence...
 
Notifications
Clear all

Purchasing Sequences

36 Posts
7 Users
0 Reactions
6,870 Views
Posts: 1065
Topic starter
(@olingerjccj)
Noble Member
Joined: 17 years ago
MartinMueller2003 wrote:
That one does have a tx light. If it is not lit, then nothing is being sent to the wires.

And I have four of them in the basement. They were very reliable for me when I used PX1.

The red is on, is that one just power blue is transmission and will flicker when I move stuff around but does not flicker when I run a sequence. So even if the renard is not picking up data sould it flicker if the connection from the cpu is sending out data. If yes then my issue is my cpu


Reply
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

You dont need to run a sequence. You just need Vixen 3 active. If everything is set up properly, V3 is always sending data to the active controllers. The data says "off, off...." but it is still data. If the Adapter TX is lit, then we need to look at the wires and how they are actually connected. Time to get out the ohm meter.


Reply
Posts: 1065
Topic starter
(@olingerjccj)
Noble Member
Joined: 17 years ago
MartinMueller2003 wrote:
You dont need to run a sequence. You just need Vixen 3 active. If everything is set up properly, V3 is always sending data to the active controllers. The data says "off, off...." but it is still data. If the Adapter TX is lit, then we need to look at the wires and how they are actually connected. Time to get out the ohm meter.

I wish I had one. I am old school using vixen 2.1. For just this year. The tx light is the blue? which is not on


Reply
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

On device manager, what is the com port for the usb adaptor?
What com device is configured for the controller.


Reply
Posts: 1065
Topic starter
(@olingerjccj)
Noble Member
Joined: 17 years ago
MartinMueller2003 wrote:
You dont need to run a sequence. You just need Vixen 3 active. If everything is set up properly, V3 is always sending data to the active controllers. The data says "off, off...." but it is still data. If the Adapter TX is lit, then we need to look at the wires and how they are actually connected. Time to get out the ohm meter.

I wish I had one. I am old school using vixen 2.1. For just this yearThe tx light is the blue? which is not on

MartinMueller2003 wrote:
On device manager, what is the com port for the usb adaptor?
What com device is configured for the controller.

Com 5 and vixen shows com 5

MartinMueller2003 wrote:
On device manager, what is the com port for the usb adaptor?
What com device is configured for the controller.
20251116 190321

Reply
Page 7 / 8
Share: