PropController Ethe...
 
Notifications
Clear all

PropController Ethernet - Construction question

31 Posts
8 Users
0 Reactions
17.6 K Views
Posts: 2630
(@dynamoben)
Famed Member
Joined: 19 years ago
DynamoBen wrote:This is just a text issue on the schematic, the PCB is correct.

Matt is right I am wrong, nice catch! The schematic is correct in that its wrong, that particular part has a different pinout than what appears in the schematic. I'm reving the board now.

In addition as Matt pointed out the circuit will still function, its just not correct.


Reply
Matt_Edwards
Posts: 2664
Topic starter
(@matt-edwards)
Famed Member
Joined: 18 years ago

For your new layout, another thing to consider is the the centre pin is usually on curved side not the flat side of the component. In fact a fair number of transistors in TO-92 case come with their legs pre-bent in this format.


Reply
Posts: 2630
(@dynamoben)
Famed Member
Joined: 19 years ago
Matt_Edwards wrote:For your new layout, another thing to consider is the the centre pin is usually on curved side not the flat side of the component. In fact a fair number of transistors in TO-92 case come with their legs pre-bent in this format.

I'll have to change the library for that one since this is the default pad config.


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

So - - are you saying that for those that have built this (and I assume the DMX version as well) that this part has probably been installed incorrectly? I'm using the PropPlug so not too concerned about it myself but it would be good to know for others.


Reply
Posts: 2630
(@dynamoben)
Famed Member
Joined: 19 years ago
budude wrote:So - - are you saying that for those that have built this (and I assume the DMX version as well) that this part has probably been installed incorrectly?

It's installed correctly but two pins are swapped (2 & 3) on the PCB. Long story short, the board will function correctly even with this mistake.

That transistor is used to toggle the reset on the prop when programming it. I've used this design with this mistake for 2 years and have never had an issue.


Reply
Page 2 / 7
Share: