Hi all-
Here is my dilemma. I have set up a 2D tree with 7 strings of 100 pixels each strung up and down. They are the DIYledexpress ws2811s. I have a 30 amp power supply and am assuming (you know what that means) that they draw 4 amps each. So 7 Strings X 4 amps = 28 amps so I would only need one power supply. I am running an e682. Would I be better off using two 30 amp power supplies, One to each power input?
Its my first attempt at RGB and the wife will not except failure.
Thanks
Andy
5v or 12v pixels?
If they are 5v pixels then 7*100*0.06A= 42A You need another supply.
With 5v pixels it will be close but may work. I like at least 20% extra capacity with my power supplies. I actually plan at 50%.
I was told each string of 50 pixels at full white is 3amps so you have 7 strings of 100 that's 6 amps per string so 7x6 is 42 amps running everything at full white
TazChaLet wrote:I was told each string of 50 pixels at full white is 3amps so you have 7 strings of 100 that's 6 amps per string so 7x6 is 42 amps running everything at full white
that is up for debate
some pixels are 30ma @ full white so 50 pixels would only draw 1.5a .
I tested mine and came out with a dif rating on my 50 but was told a regular dmm doesn't measure them right so too be honest for me it is hard too know what the real draw on them are but going by what is posted from the companies that sell them and what others say most state .06 so 3a per 50
Sorry they are 12 volt. Looks like two Power supplies for me. Anyone know of a case that could hold 2 PS and a 682?
I live just outside of Boston MA. I cant keep those things dry. I am however using your guide to make my tree 🙂
It's survived Arizona monsoon rainstorms for 2 years. I usually put a rock up under the top side which gives an angle that keeps rain from going in the hole on the bottom. The way everything is mounted it could actually withstand about a 1/4 of water inside but it doesn't get wet. You can see it has rain water on the lid in that photo. It does get really hot in AZ during December so I usually put a board over it to prevent direct sunlight from heating it up. I've run it all month long both years without powering it down. Anyways just tossing out the idea. I started getting CG-1500's this year and to be honest they seem like a pain in the butt with everything cramped inside.

