Notifications
Clear all
Pixels and Pixel controllers
16
Posts
8
Users
0
Reactions
6,437
Views
Jan 08, 2020 4:49 pm
harpster wrote:Being around electronic manufacturing for a long time and spending a lot of time in Asia factories that make “electronics stuff” I would be kinda surprised if there wasn’t an end of line test to (at least at a minimum) light up each strand. It’s hard to buy that all these Pixel strands are shipped on a random sample test only.
I know that Ray tests the stuff he ships, but I meant the actual LEDs at the LED factory, not the end product assembled by the people we buy from.
mrgrumpy wrote:If I get a 3% failure rate from my supplier, I would demand a full credit return, and work with them to get the right product, or purchase elsewhere. I'm been fortunate with 0% failure of my bullet pixels, and in my book; anything above 0.1% failure rate is too high
I think that most of that failure rate is absorbed at the "assembler" level (like Ray, ScottLED, Paul, etc.) since the defective part often fails on startup, so most likely the defects we get are those that fail after initial burn-in.
Page 4 / 4
Prev
