Working on a new pi...
 
Notifications
Clear all

Working on a new pixel controller.

33 Posts
16 Users
0 Reactions
8,884 Views
OriginalHotrodder
Posts: 311
(@originalhotrodder)
Reputable Member
Joined: 18 years ago

That sounds very exciting! Looking forward to seeing more as it comes out. Thanks for supporting the 3001. It's my pixel of choice.

Sent from my SCH-I535 using Tapatalk


Reply
Posts: 313
(@ee351)
Reputable Member
Joined: 13 years ago

Is the Ethernet connection board Microchip's LAN8720A PHY Daughter Board?


Reply
dpitts
Posts: 1020
Topic starter
(@dpitts)
Noble Member
Joined: 16 years ago

We have looked into cost but there are several things we are looking at related to how we would distribute the controller to those that are interested in it. FalconChristmas.com is a non profit website so in that spirit we will be trying our best to provide the most cost effective way to get the controller in the hands of the end user.

Here is where we are at. The code to run the controller from the PI or Pixelnet is pretty much done since we have done this ability on several FalconChristmas products already. The standalone E131 input board has been designed and sent out to board house and is in the mail right now. If this board works as planned we will have hurdled the biggest obstacle in the way. And the obstacle may not even be big it is just uncharted territory for us. We made this board all through-hole except one part, the uC. We did this to allow the end user to build the board in kit form if they choose to to reduce the cost. We will however offer an assembled board. The price for each of these options will be similar to the cost of the least expensive controller today.


Reply
dpitts
Posts: 1020
Topic starter
(@dpitts)
Noble Member
Joined: 16 years ago
EE351 wrote:Is the Ethernet connection board Microchip's LAN8720A PHY Daughter Board?

No that board was too much and the availability also looked a little slim at this point. We developed an all but one part through-hole board based on this part from TI. We used the reference schematic that was part of the Microchip Ethernet starter kit that had the PIC32MX chip onboard.
http://www.mouser.com/Search/ProductDetail.aspx?R=DP83848CVV/NOPBvirtualkey59500000virtualkey926-DP83848CVV/NOPB

The parts for the board in qty 1 is about $19.00 + $2-3 PCB.


Reply
Electrified3
Posts: 716
(@electrified3)
Prominent Member
Joined: 13 years ago

Just a quick look at the numbers, are you going from 12 bit to 16 bit with the new chip to go from 16 universe to the 64 universe?

Just quick math, are we saying from roughly 2000 pixels per controller up to around 11,000? But if limit is 500 per output then a total of 8000 per controller with 16 outputs, but the option of a power injection board to actually feasibly get it?

Wow, if I am understanding this right, then this is VERY KEWL, huge potential here!


Reply
Page 2 / 7
Share: