What kind of connectors are people using and happy with for pixels and power injection?
I have a combination of the pigtail connectors from diyledexpress and automotive weatherproof connectors I found on ebay (example).
I like the idea of a weatherproof connector that doesn't require soldering or heatshrink. I'd also like something standardized and easily available. The ones I tried were not very good. Difficult to assemble and not really weatherproof so they get corroded.
It seems that most people are using the pigtails from one vendor or another. I was planning to purchase more pixels from diyledexpress and having the pigtails already connected to the strings is a nice.
I've seem some people mention using the Delphi Weatherpack. These look like a better version of the connectors I started with. For those that have used them, how have they held up? Do you plan to continue using them?
Any other options people are happy with?
I have two variants. On my megatree I use exclusively the diyledexpress plugs for pixel strings and have built a power distribution unit wired for the "t" connectors for power injection.
For other elements I have been using the eBay plugs you showed for power. I also have been adding a dedicated pixel extender to each new element so I don't have to worry about data cable length and can power the element in multiple spots as well as the controller with a single plug (or multiple depending on power requirements).
Keeps new elements together as a kit only requiring a power plug and cat5 to get it going.
With pixel extenders at $10 and e1.31 bridges at $15/output this seemed to be the cheapest way to do this.
Sent from my iPhone using Tapatalk
I used the Delphi Weatherpack for all my pixel connections. I have no splices in any of my lines as a result. They survived temperatures ranging from 0 to 60 degrees with rain and snow without a single issue. I both crimped and soldered the connections. I know it probably takes more time versus just splicing pigtails but as an automotive engineer and mechanic, I've seen too many splices that corroded and either lost connection or fell apart. Clearly, these were in much more difficult operating environments over several years with road salt, etc. Most guys on this forum do very well going the spliced pigtail route using sealing heat shrink tubing (marine) to seal the splices. If you buy your lights from a source like DIY LED Express ( http://www.diyledexpress.com/ ), I believe they are now selling their pixel strings with weatherproof connectors already installed. The pre-sale is on now so you might want to look there to cut down on your workload.
craiz wrote:automotive weatherproof connectors I found on ebay (example).I like the idea of a weatherproof connector that doesn't require soldering or heatshrink.
I am using the exact same connectors. But I crimp AND solder the connectors. Not really necessary but I believe it will last longer. So far I am using those in the third year and those are still working perfectly.
I use Delphi Weatherpacks also and never had an issue. They're nice because you can use different gauges of wires in one plug. In my 3-wire plug I have 18 gauge for power and 22 gauge for data. I have also used Deutch connectors but they way more expensive and so is the tool.
Sent from my SM-T710 using Tapatalk
