Vixen + E682 Issues
 
Notifications
Clear all

Vixen + E682 Issues

20 Posts
6 Users
0 Reactions
4,097 Views
Posts: 16
Topic starter
(@paulmc49255)
Eminent Member
Joined: 12 years ago
davis80 wrote:You can do one of two things.....either update Vixen or your controller and Vixen.

In Vixen, you need to change start channel to be 1 for each universe. Easy change but makes for a lot of wasted channels.

On controller you need to change output group 2, start universe 1 channel 163. Output group 3, start universe 1 channel 325. Output group 4, start universe 1 channel 487. And you also need to update Vixen accordingly.

Hopefully someone comes along who is a lot more familiar with it than I am.

Is this what you mean? I am a bit lost

Untitled4

Reply
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

yeah just looked and read this about the v+

paulmc49255 wrote:In the E682 Manual, it states that a jumper wire is only needed in the + side from J19 to J18 to power both sides of the board.

Reply
Posts: 16
Topic starter
(@paulmc49255)
Eminent Member
Joined: 12 years ago

Could it have todo with something on the board? Perhaps J22 (Balanced Outputs)?


Reply
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

on mine j22 is no connect on all of them


Reply
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

if you have team viewer I could connect and see if I could help by looking at your settings


Reply
Page 3 / 4
Share: