Vixen + E682 Issues
 
Notifications
Clear all

Vixen + E682 Issues

20 Posts
6 Users
0 Reactions
4,087 Views
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

I see in your pic of the controller you dont have gnd connected too the left side of board


Reply
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

them are the power wires I guess from power supply and then red wire jumps over too j18 but no gnd

Spyder wrote:What is that white wire in J19 :ohmy:

Reply
Posts: 317
(@spyder)
Reputable Member
Joined: 11 years ago
TazChaLet wrote:them are the power wires I guess from power supply and then red wire jumps over too j18 but no gnd

It looks a very thin cable to be main supply. :pinch:


Reply
Posts: 16
Topic starter
(@paulmc49255)
Eminent Member
Joined: 12 years ago

In the E682 Manual, it states that a jumper wire is only needed in the + side from J19 to J18 to power both sides of the board.


Reply
Posts: 16
Topic starter
(@paulmc49255)
Eminent Member
Joined: 12 years ago

I am only using it as a test. Installed I plan on using appropriately sized wire.


Reply
Page 2 / 4
Share: