I have two built in Ethernet connections on my current motherboard.
One is configured to my Internet cable modem, so when my Browser is open, it uses this connection
One is set up to run the E681
When I try to access the E681 config page, I have to Force it (3 led flash method).
Anyone else use multiple Ethernet cards/connections for 'net and E68x?
Put the E68x on it's own subnet. In the config for the network card connected to the E68x set a static IP within the same subnet as the E68x, set the net mask but do not set a gateway address.
Thanks Todd, I'll give it a try
and don't forget to set a static IP on the 682 as well.
Make sure the static range you pick is DIFFERENT from the one connected to your cable modem, but the same between the PC and the 682
For example if your card connected to the cable modem is 192.168.1.100 with a subnet mask of 255.255.255.0 then set the 2nd NIC to 192.168.2.1 and the 682 would be 192.168.2.2 both with a subnet mask of 255.255.255.0. when using a class c subnet (255.255.255.0) You can sort of think of the 3rd number as the network number, and the fourth as the address.
Different network address and subnet is a good thing, as Todd said.
I picked 10.10.10.10 as my PC's network address. And had my E68x's at 10.10.10.12, .14, .16, .18 and so on. It's not necessary to skip numbers, it was just my decision.
This address is just for the web config page. It uses different addresses to actually send the E1.31 data from the PC to the controllers.
Make sure you pick the right network card when you setup the output plug-in in your sequencer.
Depending on what software you are using you may have to add a route to you PC to point multicast traffic out the second card. By default most PCs will send the multicast traffic out the card that had the default route associated with it.
Thanks
Got it sorted out,
Set the Ethernet connection to 10.10.10.99 subnet 255.255.0.0 (Also renamed the connection to 'E68x_connection' to make is easier to configure the plugins)
Set the E681 to 10.10.10.20 subnet 255.255.0.0
For some reason I had to exchange the Ethernet connections. Local Area Connection to the 'net is now the E68x_connection, Local Area Connection 2 is now the connection to the cable modem.
YOu might want to reduce your subnet mask yours is very big and no need to have one as big as you do.
maybe change it to 255.255.255.0 this will give you 254 host on your local network. If you want to go smaller you can but you will need to watch your IPs to ensure you are in the proper subnet.
The 10.x.x.x subnet is considered a local subnet, just like the 192.168.x.x one. It shouldn't get routed anywhere outside of a local network unless you really mess with the routing tables. The 10. address is a Class A IP network, which means the first number (10) is the network and it has LOTS of possible hosts in it. Technically the subnet mask for this should be 255.0.0.0, but you make it what you want. For your sanity sake, just make the subnet mask the same on your PC for that network card and on the E68x.
Again, the IP address is only to access the web config page, and isn't used to send multicast/unicast data to the controller.
Most of the output plug-ins on Vixen, LSP and others allow you to pick which network card to send out the traffic. Not sure how LOR does it.
