I have been driving myself crazy trying to get my 682 to work with my renard boards.
I have been through every bit of info I can find.( most at different places and having to do many searches)
I have checked wiring from 682 to the renard ( 1-ground 2- ground 4-data- 5-data+ )
Jumper on j22 for 2 wire balance.
I have output 4 set to Renard and the sacn/e1.31 set up correctly
I have all my universes set up correctly.
All patching setup correctly in Vixen 3,controllers activated in V3.
I have tested the renard board with a serial connection so I know it works.
Any thoughts on what to check to try and get this working would be greatly appreciated ( this is my last step to get my show working)
or is there a trouble shooting chart someplace that I cant find.
Thanks
I suggest you start the Renard on a separate universe and attempt a separate vixen setup (or better yet use sACNView) to iron out the E1.31->Renard portion first. If you get that working it at least rules out any hw/wiring issues.
Had the same problem when I set up my E682 could not get the renard to work, I had a home built Ren_T with my Grinch system and when I looked at the wiring diagram for the REN-T it had pin 5 grounded since it was not used, all the renard needed was data coming in on pin 3. Check and see if pin 5 is grounded. I know you reset J22 but if you can ohm out pin 5 (data +) from the renard at the E682 connector just to make sure. The Renard board may also have a jumper that needs to be changed.
Gary
Good point - if you have an legacy Ren like a RenSS (you didn't say which), make sure the RS232 jumper is OFF (JP1 on RenSS). I assume you are using the RJ45 connector so you have the correct pins 4/5. You can swap them around - it won't hurt to get them mixed up (it just won't work...).
sorry yes I have the RenSS boards.
The jumper is off.
trying to verify the wiring now, I use the dmx wiring correct?
Traneman wrote:sorry yes I have the RenSS boards.The jumper is off.
trying to verify the wiring now, I use the dmx wiring correct?
I'm not sure what that means? Renards have their own wiring and it does not follow the DMX RJ45 standard (1/2 = data, 7/8 = common). The input is always pins 4/5 regardless for them - basically the Blue/Blue-White pair if using a standard Ethernet patch cord (non-crossover type).
Are you certain the E1.31 setup in Vixen is correctly sending out data in the first place? Maybe put some pixels on an output to eliminate that side of the setup?
OK well I connected a string of pixels and found my E682 is not working. I can not even get the pixels to work with a test sequence using the 682 web server.
Now I need to back up and find out why that's not working.
Any suggestions on where to start ?
From the pictures in your 1st post it looks like your first renard channel should be 4831 make sure in Vixen that that is correct, remember do not set up Vixen with any renard controllers only your E682 or E6804 which ever one you have, all the channels will be under that controller only. I can tell you that it does work because my setup looks just about like yours. Wiring is Data+ to Data and Data- to clock and pins 1&2 to ground.
Gary
Are all the led's lit on the left side? They should all be on and if a test is running the top led should be flashing very fast, if it is solid then no tests are running.
Gary

