Technicolor quality...
 
Notifications
Clear all

Technicolor quality?

256 Posts
45 Users
0 Reactions
83.3 K Views
MindTrik
Posts: 1542
Topic starter
(@mindtrik)
Noble Member
Joined: 16 years ago

Going to order the c9 faceted with my next order

Sent from a Galaxy 4s in the North Pole


Reply
Posts: 928
(@arw01)
Noble Member
Joined: 13 years ago

I have a sample of the g40 coming in from Ray next week. The faceted pixabulbs look great closer and the frosted when further away.

Sent from my Sony Tablet S using Tapatalk


Reply
jklingert
Posts: 1767
(@jklingert)
Noble Member
Joined: 16 years ago

Can someone explain exactly what the difference is between the Technicolor Pixels that caused issues for folks last year were and the "new redesigned" version?

I had seen posts with a lot of potential issues with the old ones, and I am curious if the various issues have been addressed. There was talk of a bad regulator, wrong resistors, thin copper, water leakage, bad molding, etc.....

I still wonder if a injection molded pixel base will ever seal to the pvc wires well enough in a moist climate. It seems like every other pixel type has gone to epoxy encapsulated boards that have been conformally coated to solve the issue of water ingress.


Reply
MindTrik
Posts: 1542
Topic starter
(@mindtrik)
Noble Member
Joined: 16 years ago

as far as I know it was a World Semi component causing most of the issues...a regulator I believe. In addition, there was a problem I believe with how the wires were bing attached. All the problems were addressed AFAIK. The other was a coating that may or may not have been put on during manufacture. I have resin pixels as well, but even some of those have exposed components where the PCB didn't get covered fully.


Reply
Posts: 1076
 Zeph
(@zeph)
Noble Member
Joined: 15 years ago

Like many, I was excited by the promise of the technicolors, then disappointed by all the problems before the redesign. So I went into wait and see mode.

Are people becoming confident enough to start placing larger orders again?

Also - Ray's description includes this line:

IC type: WS2811 (we can also use TM1804 or TM1829)

Has anybody tried to get a non-WS2811 version from Ray? Or was the new design specific to just the WS2811?


Reply
Page 46 / 52
Share: