Technicolor quality...
 
Notifications
Clear all

Technicolor quality?

256 Posts
45 Users
0 Reactions
83.4 K Views
Posts: 214
(@gary-martin)
Estimable Member
Joined: 18 years ago

Here's the rest of the pictures I got from the thermal failure TC string:

First for reference, here is a good TC pixel after opening the injection molding with a Dremel and box knife:

The rest of these pics aren't as pretty:

Opening the burnt pixel:

One last shot of a good pixel:


Reply
Posts: 853
(@roterhead)
Prominent Member
Joined: 15 years ago

Those look like short circuit thermal runaway.... wow...


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago
Roterhead wrote:Those look like short circuit thermal runaway.... wow...

wow is right - wow!


Reply
Posts: 1076
 Zeph
(@zeph)
Noble Member
Joined: 15 years ago
Roterhead wrote:Have to be careful about current flows in the DC vs AC world.

AC flows only in the outer circumference of a wire (called skin effect), something to do with actual electron flow and migration. In very high frequency systems hollow tubes (waveguides) are used as current is only flowing in the skin of the conductor.

DC flows throughout the conductor thus cross section area needs to be looked at.

Exactly. However the skin effect is minimal for small cables at low AC frequencies. In any case, being highly stranded would not allow a less than 18Ga wire to act the same as an 18Ga wire in the pixel context (from referenced claim in some earlier msg in the thread).


Reply
MindTrik
Posts: 1542
Topic starter
(@mindtrik)
Noble Member
Joined: 16 years ago

Any updates on the new ones yet?


Reply
Page 40 / 52
Share: