Technicolor Pixels ...
 
Notifications
Clear all

Technicolor Pixels ARE NOT FIXED

251 Posts
31 Users
0 Reactions
70.1 K Views
MindTrik
Posts: 1542
(@mindtrik)
Noble Member
Joined: 16 years ago

Send them to Ray to see what he sais


Reply
jklingert
Posts: 1767
(@jklingert)
Noble Member
Joined: 16 years ago

They look like they are missing a resistor. The data sheet calls for 3 resistors, two 33 ohm resistors on the data in and data out, and a 100 ohm resistor on the Vdd when they are running at 5V. Since they are using a 78L05, the 2811 is running at 5V. Looking at the image there are two 25 (75?) ohm resistors?


Reply
bcwhitehead
Posts: 119
Topic starter
(@bcwhitehead)
Estimable Member
Joined: 15 years ago

I did send them to Ray. His response was " thanks for your mail and information.
i invested lots of money and time on this technicolor pixel , i will not give up,we will put the gule on it,and put a better Three anti-adhesive glue on the pcba before molding.and try to solve the water issue"


Reply
MindTrik
Posts: 1542
(@mindtrik)
Noble Member
Joined: 16 years ago

If I have problems...it will be a letdown for sure this year...


Reply
bcwhitehead
Posts: 119
Topic starter
(@bcwhitehead)
Estimable Member
Joined: 15 years ago

Its very much one for me. I have fixing them as I can but woke up to another string half white this morning. After they were all working fine yesterday minus 1 pixel that was stuck on blue. Plus it was really warm and dry. It did rain last night. I asked for a full refund. This is a huge let down. He needs to fix these properly and not suggest putting glue on them as fix that a band aid fix. The glue will break down sooner than later. Anyone have any of DIY LED 50cnt 12v ws2811 that didn't make it into the they're display? LOL


Reply
MindTrik
Posts: 1542
(@mindtrik)
Noble Member
Joined: 16 years ago

Pixabulbs have failures too..albeit not to this extent. Did you say you did or did not have C9 covers on?


Reply
bcwhitehead
Posts: 119
Topic starter
(@bcwhitehead)
Estimable Member
Joined: 15 years ago

No covers on them. I know pixabulbs have failures I have replaced about 10 pixels on pixabulbs also this year due to moisture also getting in. Some just condensation and some have standing water in them.


Reply
Posts: 419
(@txag2008)
Honorable Member
Joined: 17 years ago

When you replace these nodes are you making 6 different soldered connections and then heat shrinking? Just curious since it seems like a lot of work (although I really don't think there's any better way...)

Sent from my iPhone using Tapatalk


Reply
bcwhitehead
Posts: 119
Topic starter
(@bcwhitehead)
Estimable Member
Joined: 15 years ago

Yep solder an heat shrink.


Reply
MindTrik
Posts: 1542
(@mindtrik)
Noble Member
Joined: 16 years ago

I did quick repairs sometimes...twisting and taping with red electrical tape so I could do a permanent repair later


Reply
Page 7 / 26
Share: