I have a garage roof outline, where there are two pixels that remain blue, and one flickers blue somewhat, without the Falcon F16V3 running anything. These are 5v bullet pixels, put into service last year. The string is composed of 4 segments: 50 - 57 - 57 - 50, with power injected after the 1st 50, and again prior to the last 50. There is no power being supplied via the xConnect wires, only data + ground. Distance from controller to 1st pixel is < 10'. Power wires are either 16 or 14 gauge, and are 15 and 30' away from PSU. Problem pixels are in the second segment, about #'s 60, 64, and 67 in the overall string. When running a color wash, I can see blue light coming from the pixels, in addition to the color they *should* be.
I've disconnected the xConnect cable, applying only power, and the problem remains. I've also run the string off an esPixelStick, applying power via the xConnect (and not from the other injection points), and problem does not occur. However, in this instance, the string is woefully underpowered. I've also tried running from the ESP, with no power coming from it, and injecting from a different PSU, and problem is there. I've verified that the two injection points are being fed from the same PSU. Are these pixels going bad? Should I cut out the one prior to the problem pixel, and up to and including the last stuck pixel?
Thanks,
-pc
You replace last working and first non working, Most likely the rest are victims.
