Notifications
Clear all
Dec 09, 2017 9:20 pm
SO this is what my tree does in test mode. Will eventually right itself.
Dec 10, 2017 7:49 am
jerry72 wrote:I have tried testing with xlights and FPP, the tester on the UI page works correctly, but i can not test individual channels with it.
You can test individual channels in FPP. Just put the correct contiguous channel range in boxes near the top. I doubt if your issue is firmware. You have a set up problem in either Xlights or FPP. Your E682 looks right.
Dec 10, 2017 3:41 pm
jerry72 wrote:I have tried testing with xlights and FPP, the tester on the UI page works correctly, but i can not test individual channels with it.
On the FPP player page you can test individual channels. Just under "Enable Test Mode" there is " Channel Test Range". I'm not familiar with Xlights but I'm sure you can test individual channels. Go to "Tools, test" and the channels are listed. To activate just a channel double click on the box next to the listed channel. To test all channels double click on the box next to the controller listed.
Sent from my SM-T710 using Tapatalk
Page 2 / 2
Prev
