string changes colo...
 
Notifications
Clear all

string changes color at one node

5 Posts
4 Users
0 Reactions
2,036 Views
Posts: 890
Topic starter
(@ben-bobbi)
Noble Member
Joined: 17 years ago
[#53079]

I have 4 strings, one on each of 4 different elements that change color at one node. meaning when i run the test display from FPP 3/4 of the string is red, and the last 1/4 is blue (might have been green), bottom is blue, top is green (might be red) you get the idea.

Any ideas what causes this? My guess is the bad node which only lights green needs replaced. Usually a bad node just stops and the rest of the string is out.


4 Replies
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago

My guess would be a bad pixel. I had a megatree that had one blue pixel. I replaced it and the one before it and all is well.

Sent from my SM-T710 using Tapatalk


Reply
Posts: 128
(@sctwohig)
Estimable Member
Joined: 10 years ago

How longs the string if it is correct at 170 and a different color at pixel 171 then you might have your channels set to 510 in fpp and they should be 512, Make sure fpp matches your controller.

--
Shawn


Reply
Posts: 5
(@super6o)
Active Member
Joined: 11 years ago
sctwohig wrote:How longs the string if it is correct at 170 and a different color at pixel 171 then you might have your channels set to 510 in fpp and they should be 512, Make sure fpp matches your controller.

--
Shawn

Absolutely this. Check that your channel boundaries/universe sizes match.


Reply
Posts: 890
Topic starter
(@ben-bobbi)
Noble Member
Joined: 17 years ago

looks like that was it. the 4 elements were on 2 of my new controllers. they were set to 512, reset to 510, and the elements are all one color now.

thanks for the help


Reply
Share: