Hi, I have some square nodes I bought from Ray in 2019 and another batch in 2020. We used some of them at the beginning of this season and we had a ton of failures with them from what looks like water infiltration. They are 2811 regulated square nodes and are epoxy filled. The problem is I don’t know which ones are which or if there is even a way to tell the difference. Did anyone else have problem with Ray square nodes over the last few years? The square node strands from 2020 for our mega tree have been working great it’s just others that I am having problems with. I suspect they are the 2019 ones but cannot tell. Any feedback on issues others have had or ways to tell the faulty ones would be greatly appreciated. Thanks
Look at the epoxy, on mine that I got that year, the epoxy is cracked. I have had many failures this year from square node I bought in 2019, but did not use till last year and this one. I have 4 wire square nodes from 2010 till 2018 that have had less than 1% issues over three years (about 12,000 pixels). I switched to 3 wire (WS2811) in 2019, total this year I have had to replace about 100 from 2019, from a 1000 pixel order. The only thing I found that helped, was Gorilla sealant, clear. I sprayed the backs of the nodes in an effort to slow the water seepage down, but that is only a band aide. I am assuming they mixed the epoxy too hot (too much activator) in an effort to speed up the curing time.
