Seed Pixels: Short ...
 
Notifications
Clear all

Seed Pixels: Short Wire Connection Tips/Tricks?

3 Posts
3 Users
0 Reactions
1,529 Views
Posts: 32
Topic starter
(@marksat)
Trusted Member
Joined: 8 years ago
[#57018]

All,

I am thinking about a new megatree using the 2.5 cm (about 1") spacing seed LEDs. That spacing does not leave a lot of room for splicing connectors, etc. I am thinking maybe the "clickits" or lever-type nuts instead of stripping/soldering/etc.

Any tips or other suggestions (or am I better off with with doubling up 2" spacing lights with the "alternate node" method)?

Thank you in advance.


2 Replies
Posts: 1420
(@1pet2-9)
Noble Member
Joined: 6 years ago

I meant to ask the same question. That spacing is so small.


Reply
Posts: 36
(@maraku)
Eminent Member
Joined: 6 years ago

Soldering another wire to 2.5cm seed pixels seems like a huge pain. Mainly because there is not enough room to slide heatshrink onto.
My suggestion would be soldering to a small pcb.

Something like this, but with the pcb pads in-line to the edge.
https://www.hansonelectronics.com.au/product/pixjoiner

Pixjoiner3

This can be achieved with blank PCBs.

blank pcbs

Otherwise 'Click-It' or Scotch Loks would be perfect, and a lot easier than what I mentioned!


Reply
Share: